2004-078 - Laserfiche WebLink

Home Browse Search

carbide ring with each pair held in contact by a separate spring , so that the outside pressure assists spring compression in preventing the seal faces from opening . The compression spring shall be protected against exposure to the pumped liquid . The pumped liquid shall be sealed from the oil reservoir by one face seal and sealed from the oil reservoir from the motor chamber by the other. The seals shall require neither maintenance nor adjustment, and shall be easily replaced . Conventional double mechanical seals with a single spring between the rotating faces , requiring constant differential pressure to effect sealing and subject to opening and penetration by pumping forces , shall not be considered equal to tandem seal specified and required . 4 . A sliding guide bracket shall be an integral part of the pumping unit, and the pump casing shall have a machined connecting flange to connect with the cast iron discharge connection , which shall be bolted to the floor of the sump with stainless steel anchor bolts and so designed as to receive the pump connection without the need of any bolts or nuts . Sealing of the pumping units to the discharge connection shall be accomplished by a simple linear downward motion of the pump , with the entire weight of the pumping unit guided by 304 stainless steel guides which will press it tightly against the discharge connection . No portion of the pump shall bear directly on the floor of the sump , and no rotary motion of the pump shall be required for sealing . 5 . Pump motors shall be housed in an air-filled , watertight casing . Motors shall be a NEMA Design B with a 1 . 15 service factor. Insulation shall be moisture-resistant NEMA Class F with a maximum temperature rise of 90 degrees Celsius above ambient temperature (4 degrees Celsius ) . Motor characteristics are noted on the Drawings . Pump motors shall have cooling characteristics suitable to permit continuous operation , in a totally , partially or non- submerged condition . Each motor shall incorporate an ambient temperature compensated overheat sensing device and a moisture sending device wired in series . The protective devices shall be wired into the pump controls in such a way that if either device operates , the pump will shut down . The devices shall be self- resetting . The cable shall be fixed to the pump using a watertight trumpet assembly. The pump shall be capable of running continuously in a totally dry condition under full load , without damage , for extended periods . Before final acceptance , a field running test demonstrating this ability, with four (4 ) hours of continuous operation (water supplied by the contractor) under the above conditions , shall be 8 - 5