2008-213 (5) - Laserfiche WebLink

Home Browse Search

maintenance personnel unfamiliar with such equipment. The number and special requirements shall be as specified by the County, 2. A factory representative of all major component manufacturers, who has complete knowledge of proper operation and maintenance, shall be provided for one (1) day to instruct representatives of the Owner and the Engineer on proper operation and maintenance. If there are difficulties in operation of the equipment due to the manufacturer's design or Contractor's installation, additional service shall be provided by the Contractor at no cost to the Owner. 1.05 TOOLS AND SPARE PARTS A. One (1) set of all special tools required for normal operation and maintenance shall be provided. All such tools shall be furnished in a suitable steel tool chest complete with lock and duplicate keys. The manufacturer shall furnish a complete set of recommended spare parts necessary for the first five (5) years operation of the pumping system, which shall include at least the following: 1. 1 - set of upper bearings for each pump supplied 2. 1 - set of lower bearings for each pump supplied 3, 1 - set of upper and lower shaft seals for each pump supplied 4. 2 — replacement fuses for each installed fuse 5. 1 — relay and phase monitor for each type supplied with the pump control panel 6. 1 — spare impeller B. Spare parts shall be properly bound and labeled for easy identification without opening the packaging and suitably protected for long term storage. 1.06 WARRANTY A. All equipment supplied under this section shall be warranted for a period of one (1) year by the Contractor and the equipment manufacturers. Warranty period shall commence on final date when project is accepted by the. Owner. B. The equipment shall be warranted to be free from defects in workmanship, design and materials. If any part of the equipment should fail during the warranty period, it shall be replaced and the machine(s) and/or the unit(s) restored to service at no expense to the Owner. C. The manufacturer's warranty period shall run concurrently with the Contractor's warranty period. No exception to this provision shall be allowed. PART 2 - EQUIPMENT AND MATERIALS 2.01 PUMP FOUNDATION PLATES A. Each pump shall be furnished with a foundation base plate which shall be rigidly and accurately anchored into position. The pump manufacturer shall furnish all necessary foundation bolts, plates, nuts, and washers for installation by the Contractor. Each foundation plate shall be '/2" thick, Type 316 stainless steel. Foundation bolts, nuts, washers, and spare parts shall be Type 316 stainless steel. 2.02 SEWAGE PUMPS 02539 — Submersible Pump Station (Rev.) 02539-3 r�