Laserfiche WebLink
2 .4 FABRICATION <br /> �•• A. Floor-and-Ceiling-Anchored Units : Provide manufacturer's standard corrosion-resistant anchoring <br /> assemblies with leveling adjustment at tops and bottoms of pilasters . Provide shoes and sleeves (caps) at <br /> pilasters to conceal anchorage . <br /> B . Door Size and Swings : Unless otherwise indicated, provide 24-inch- (610-mm-) wide, in-swinging doors <br /> for standard toilet compartments and 36-inch- (914-mm-) wide, out-swinging doors with a minimum 32- <br /> inch- (813-mm-) wide, clear opening for compartments designated as accessible . <br /> PART 3 - EXECUTION <br /> 3 . 1 INSTALLATION <br /> A. General : Comply with manufacturer's written installation instructions . Install units rigid, straight, level, <br /> and plumb . Secure units in position with manufacturer's recommended anchoring devices. <br /> 1 . Maximum Clearances: <br /> a. Pilasters and Panels : 1 /2 inch ( 13 nun) . <br /> b . Panels and Walls : 1 inch (25 mm) . <br /> B . Floor-and-Ceiling-Anchored Units : Secure pilasters to supporting construction and level, plumb , and <br /> tighten. Hang doors and adjust so doors are level and aligned with panels when doors are in closed <br /> position. <br /> 3 .2 ADJUSTING <br /> A. Hardware Adjustment: Adjust and lubricate hardware according to hardware manufacturer' s written <br /> instructions for proper operation. Set hinges on in-swinging doors to hold doors open approximately 30 <br /> degrees from closed position when unlatched. Set hinges on out-swinging doors and doors in entrance <br /> screens to return doors to fully closed position. <br /> END OF SECTION 10155 <br /> L <br /> Wabasso Beach Park 10155 - 4 <br /> Indian River County <br /> DAA Project No. 6008 <br />