2011-226B.1 - Laserfiche WebLink

Home Browse Search

IN WX 777W7 a IN 41 N N IN I IN 6 - 3 . 4 Storage Facilities For Samples : Provide facilities for storage of samples as described in the Contract Documents and warranted by the test methods and Specifications . 6-4 Defective Materials . Materials not meeting the requirements of these Specifications will be considered defective . The Engineer will reject all such materials , whether in place or not . Remove all rejected material immediately from the site of the work and from storage areas , at no expense to the Department . Do not use material that has been rejected and the defects corrected, until the Engineer has approved the material ' s use . Upon failure to comply promptly with any order of the Engineer made under the provisions of this Article, the Engineer has the authority to have the defective material removed and replaced by other forces and deduct the cost of removal and replacement from any moneys due or to become due the Contractor . As an exception to the above , within 30 calendar days of the termination of the LOT or rejection of the material , the Contractor may submit a proposed scope of work to the Engineer for an engineering or independent laboratory (as approved by the Engineer) analysis to determine the disposition of the material . A Specialty Engineer, who is an independent consultant, or the Contractor ' s Engineer of Record as stated within each individual Section shall perform any such analysis . Upon the Engineer ' s approval of the scope of work submitted by the Contractor, the engineering analysis must be completed and the report must be submitted to the Engineer within 45 calendar days , or other time frame as approved by the Engineer. The report must be signed and sealed by the Specialty Engineer. The Engineer will determine the final disposition of the material after review of the information submi mtted by the Contractor. No additional monetary compensation or time extension will be granted for the impact of any such analysis or review . 6-5 Products and Source of Supply. 6- 5 . 3 Contaminated, Hazardous , and Dangerous Materials : Do not use any material that, after approval and/or placement, has in any way become unfit for use . Do not use materials containing any substance that has been determined to be hazardous by the State of Florida Department of Environmental Protection or the U . S . Department of Environmental Protection . Provide workplaces free from serious recognized hazards and to comply with occupational safety and health standards , as determined by the U . S . Department of Labor Occupational Safety and Heath Administration , SECTION 7 — LEGAL REQUIREMENTS AND RESPONSIBILITIES TO THE PUBLIC a 7 - 1 . 3 Introduction or Release of Prohibited Aquatic Plants , Plant Pests , or Noxious Weeds : Do not introduce or release prohibited aquatic plants , plant pests , or noxious weeds into the project limits as a result of clearing and grubbing, earthwork, grassing and mulching, sodding, landscaping , or other such activities . Immediately notify the Engineer upon discovery of all prohibited aquatic plants , plant pests , or noxious weeds within the project limits . Do not move prohibited aquatic plants , plant pests , or noxious weeds within the project limits or to locations outside of the project limits without the Engineer ' s permission . Maintain all borrow material brought onto the project site free of prohibited aquatic plants , plant pests , noxious weeds , and their reproductive parts . Refer to Rule 16C - 52 and Rule 513 - 57 , of the Florida - 10 - FPID ( S ) : 423186 - 1 - 5 8 - 01