2011-226B.1 - Laserfiche WebLink

Home Browse Search

b Use signs with specific business names on each sign . Install logos provided by business owners and approved by the Engineer. Standard Business entrance signs meeting the requirements of Index 17355 without specific business names may be used only with the approval of the Engineer. 102-9 .4 High Intensity Flashing Lights : Furnish Type B lights in accordance with the plans and Design Standards . 102-9 .5 Warning/Channelizing Devices : Furnish warning/channelizing devices in accordance with the plans and Design Standards . 102-9 . 5 . 1 Retroreflective Collars for Traffic Cones : Use collars for traffic cones listed on the QPL that meet the requirements of Section 990 . Use cone collars at night designed to properly fit the taper of the cone when installed. Place the upper 6 inches collar a uniform 3 1 /2 inch distance from the top of the cone and the lower 4 inch collar a uniform 2 inch distance below the bottom of the upper 6 inch collar. Ensure that the collars are capable of being removed for temporary use or attached permanently to the cone in accordance with the manufacturer' s recommendations . Provide a white sheeting having a smooth outer surface and that has the property of a retroreflector over its entire surface . 102-9 . 5 .2 Barrier Wall (Temporary) : Furnish, install, maintain, remove and relocate a temporary barrier wall in accordance with the plans . Ensure that temporary concrete barrier wall for use on roadway sections , complies with Index No . 412 , 415 or 414 as specified in the plans . Ensure that temporary concrete barrier wall for use on bridge and wall sections , complies with Index No . 414 as specified in the plans . Ensure that temporary water filled barrier wall used on roadway sections meets the NCHRP Report 350 criteria or the MASH and is listed on the Qualified Products List (QPL) . Barriers meeting the requirements of Index No . 41 2 , 415 or temporary water filled barriers on the QPL will not be accepted as an alternate to barriers meeting the requirements of Index No . 414 . 102-9 . 5 .3 Glare Screen (Temporary) : Use temporary glare screens listed on the QPL that meet the requirements of Section 990 . Furnish, install, maintain, remove and relocate glare screen systems in conjunction with temporary barrier wall at locations identified in the plans . Ensure the anchorage of the glare screen to the barrier is capable of safely resisting an equivalent tensile load of 600 lb/ft of glare screen, with a requirement to use a minimum of three fasteners per barrier section . When glare screen is utilized on temporary barrier wall , warning lights will not be required. 102 -9 . 6 Temporary Crash Cushion (Redirect/Inertia) : Furnish , install , maintain and subsequently remove temporary crash cushions in accordance with the details and notes shown in the plans , the Design Standards , and requirements of the pre - approved alternatives listed on the QPL. Maintain the crash cushions until their authorized removal . Repair all attachment scars to permanent structures and pavements after crash cushion removal . Make necessary repairs due to defective material , work, or Contractor operations at no cost to the Department . Restore crash cushions damaged by the traveling public within 24 hours after notification as authorized by the Engineer. 102-9 .7 Guardrail (Temporary) : Furnish guardrail (temporary) in accordance with the plans and Design Standards . Meet the requirements of Section 536 . - 29 - FPID (S ) : 423186 - 1 - 58 - 01