Laserfiche WebLink
INDIAN RIVER COUNTY JULY 25, 2014 <br />INTERGENERATIONAL RECREATION CENTER 100% CONSTRUCTION DOCUMENTS <br />c. Radius, 60 Inches or Larger: Equivalent to 1 percent slope, but not greater than 1 - <br />inch total depression. <br />3. Install floor -drain flashing collar or flange so no leakage occurs between drain and <br />adjoining flooring. Maintain integrity of waterproof membranes where penetrated. <br />4. Install individual traps for floor drains connected to sanitary building drain, unless <br />otherwise indicated. <br />G. Install deep -seal traps on floor drains and other waste outlets, if indicated. <br />I -I. Install floor -drain, trap -seal primer fittings on inlet to floor drains that require trap -seal primer <br />connection. <br />1. Exception:. Fitting may be omitted if trap has trap -seal primer connection. <br />2. Size: Same as floor drain inlet. <br />I. Install air -gap fittings on draining -type backflow preventers and on indirect -waste piping <br />discharge into sanitary drainage system. <br />J. <br />K. <br />L. <br />3.2 <br />A. <br />B. <br />C. <br />D. <br />1. Above -Floor Installation: Set unit with bottom resting on floor, unless otherwise indicated. <br />2. Flush with Floor Installation: Set unit and extension, if required, with cover flush with <br />finished floor. <br />3. Recessed Floor Installation: Set unit in receiver housing having bottom or cradle <br />supports, with receiver housing cover flush with finished floor. <br />4. Install cleanout immediately downstream from interceptors not having integral cleanout <br />on outlet. <br />Install wood -blocking reinforcement for wall -mounting -type specialties. <br />Install traps on plumbing specialty drain outlets. Omit traps on indirect wastes unless trap is <br />indicated. <br />Install escutcheons at wall, floor, and ceiling penetrations in exposed finished locations and <br />within cabinets and millwork. Use deep -pattern escutcheons if required to conceal protruding <br />pipe fittings. <br />CONNECTIONS <br />Comply with requirements in Section 221316 "Sanitary Waste and Vent Piping" for piping <br />installation requirements. Drawings indicate general arrangement of piping, fittings, and <br />specialties. <br />Install piping adjacent to equipment to allow service and maintenance. <br />Ground equipment according to Section 260526 "Grounding and <br />Systems." <br />Connect wiring according to Section 260519 "Low -Voltage Electrical <br />Cables." <br />Bonding for Electrical <br />Power Conductors and <br />SANITARY WASTE PIPING SPECIALTIES 221319 - 4 <br />