Laserfiche WebLink
E. Above paragraphs 1.6.13, 1.6.C, and 1.6.D do not in any way, limit the types of <br />conditions in which pollution may be determined to occur. <br />1.7 PENALTIES FOR NONCOMPLIANCE WITH THIS SECTION <br />A. In addition to the OWNER's specific remedies, if erosion or pollution is caused by <br />dewatering water or stormwater runoff from the construction site, the OWNER will <br />immediately report the violations to the Indian River County Code Enforcement Board, <br />SJRWMD, FDEP, Indian River Farms Water Control District (or other F. S. Chapter <br />298 Drainage District, as appropriate), and other pertinent regulatory or enforcement <br />agencies. <br />PART 2 - MATERIALS AND INSTALLATION <br />2.1 GENERAL <br />A. Polyacrylamide: As required in Paragraph 1.3.C, place polyacrylamide (PAM) on bare <br />ground to reduce the potential for erosion. PAM may also be used in water bodies to <br />remove turbidity. Use the anionic form of polyacrylamide that does not stick to fish <br />gills. For PAM information and its proper application, contact Applied Polymer <br />Systems, Inc., (678) 494-5998, www.siltstop.com. <br />B. Staked Silt Fences: <br />1. General: Use silt fences to control runoff from the construction site where the <br />soil has been disturbed. <br />2. Installation: Install per the manufacture's recommendations and as specified <br />herein. In general, install the silt fence in a manner that allows it to stop the <br />water long enough for the sediment to settle while the water passes through the <br />silt fence fabric. All supporting posts shall be on the down-slope side of the <br />fencing. Place the bottom of the fabric 6 -inches minimum, under compacted <br />soil to prevent the flow of sediment underneath the fence. Place silt fences <br />away from the toe of slopes. Otherwise, install in accordance with FDOT Index <br />No. 102. <br />3. Product: All material shall be new and unused. Use FDOT Types II through IV <br />silt fences where large sediment loads are anticipated, where slopes are 1:2 <br />(vertical: horizontal) or steeper, or as directed by the ENGINEER; otherwise use <br />FDOT Type III silt fence. <br />(a) For FDOT Type III Silt Fence - ACF Environmental, Catalog No. 360800000, <br />Florida DOT Silt Fence. U.S. Sieve = 30, tensile strength = 120 pounds. The <br />heavy-duty filter fabric shall be pre -attached to 48 -inch long stakes on 6 -foot <br />centers. (1-800-448-3636). <br />(b) For FDOT Type IV Silt Fence, modify the above Catalog No. 360800000 to <br />comply with FDOT Index No. 102. <br />(c) Or equivalent. <br />C. Turbidity Barriers: <br />01025-17 Technical Specifications <br />F:\PublieWorks\ENGINEERING DIVISION PROJECTS\1137-Old Dixie Hwy Resurfacing IRF North Relief Canal to 71st St\Admim\bid <br />documents\Contract Documents\Technical Specifications REVISED.doc <br />01025-18 Technical Specifications <br />F:\Public Works\ENGINEERING DIVISION PROJECTS\1137-Old Dixie Hwy Resurfacing IRF North Relief Canal to 71st StWdmim\bid <br />documents\Contract Documents\Technical Specifications REVISED.doc <br />