Laserfiche WebLink
dewatering water or stormwater runoff from the construction site, the OWNER will <br /> immediately report the violations to the Indian River County Code Enforcement Board, <br /> SJRWMD, FDEP, Indian River Farms Water Control District (or other F. S. Chapter <br /> 298 Drainage District, as appropriate), and other pertinent regulatory or enforcement <br /> agencies. <br /> PART 2 - MATERIALS AND INSTALLATION <br /> 2.1 GENERAL <br /> A. Polyacrylamide: As required in Paragraph 1.3.C, place polyacrylamide (PAM) on bare <br /> ground to reduce the potential for erosion. PAM may also be used in water bodies to <br /> remove turbidity. Use the anionic form of polyacrylamide that does not stick to fish <br /> gills. For PAM information and its proper application, contact Applied Polymer <br /> Systems, Inc., (678) 494-5998, www.siltstop.com. <br /> B. Staked Silt Fences: <br /> 1. General: Use silt fences to control runoff from the construction site where the <br /> soil has been disturbed. <br /> 2. Installation: Install per the manufacture's recommendations and as specified <br /> herein. In general, install the silt fence in a manner that allows it to stop the <br /> water long enough for the sediment to settle while the water passes through the <br /> silt fence fabric. All supporting posts shall be on the down-slope side of the <br /> fencing. Place the bottom of the fabric 6-inches minimum, under compacted <br /> soil to prevent the flow of sediment underneath the fence. Place silt fences <br /> away from the toe of slopes. Otherwise, install in accordance with FDOT Index <br /> No. 102. <br /> 3. Product: All material shall be new and unused. Use FDOT Types II through IV <br /> silt fences where large sediment loads are anticipated, where slopes are 1:2 <br /> (vertical: horizontal) or steeper, or as directed by the ENGINEER; otherwise use <br /> FDOT Type III silt fence. <br /> (a) For FDOT Type III Silt Fence -ACF Environmental, Catalog No. 360800000, <br /> Florida DOT Silt Fence. U.S. Sieve = 30, tensile strength = 120 pounds. The <br /> heavy-duty filter fabric shall be pre-attached to 48-inch long stakes on 6-foot <br /> centers. (1-800-448-3636). <br /> (b) For FDOT Type IV Silt Fence, modify the above Catalog No. 360800000 to <br /> comply with FDOT Index No. 102. <br /> (c) Or equivalent. <br /> C. Turbidity Barriers: <br /> 1. General: Use turbidity barriers to control sediment contamination of <br /> rivers, lakes, ponds, canals, etc. <br /> 2. Installation: Install per the manufacturer's recommendations and per FDOT <br /> Index No. 103 unless directed otherwise by the ENGINEER. <br /> 3. Product: All material shall be new and unused. The turbidity barrier shall be a <br /> pervious barrier and the fabric color shall be yellow. <br /> 01025-17 Technical Specifications <br /> F:\Public Works\ENGINEERING DIVISION PROJECTS\08456-Old Dixie Hwy Sidewalk(38th Ln-45th St)Wdmim\bid <br /> documents\Master Contract Documents\Technical Specifications.doc <br />