Laserfiche WebLink
ROOFING REPLACEMENT, RECOVER AND REPAIR PROJECT PAGE 7 <br />INDIAN RIVER COUNTY — JAIL COMPLEX SECTION 076200 <br />JANUARY 4, 2018 SHEET METAL FLASHING AND TRIM <br />2.6 FINISHES <br />A. Comply with NAAMM's "Metal Finishes Manual for Architectural and Metal Products" for <br />recommendations for applying and designating finishes. <br />B. Protect mechanical and painted finishes on exposed surfaces from damage by applying <br />a strippable, temporary protective covering before shipping. <br />C. Appearance of Finished Work: Variations in appearance of abutting or adjacent pieces <br />are acceptable if they are within one-half of the range of approved Samples. <br />Noticeable variations in the same piece are not acceptable. Variations in appearance <br />of other components are acceptable if they are within the range, of approved Samples <br />and are assembled or installed to minimize contrast. <br />PART 3 - EXECUTION <br />3.1 EXAMINATION <br />A. Examine substrates, areas, and conditions, with Installer present, to verify actual <br />locations, dimensions and other conditions affecting performance of work.. <br />1. Verify that substrate is sound, <br />securely anchored. <br />2. Proceed with installation only <br />corrected. <br />3.2 INSTALLATION, GENERAL <br />dry, smooth, clean, ,sloped for drainage, and <br />after unsatisfactory conditions have been <br />A. General: Anchor sheet metal flashing and trim and other components of the Work <br />securely in place, with provisions for thermal and structural movement. Use fasteners, <br />solder, welding rods, protective coatings, separators, sealants, and other <br />miscellaneous items as required to complete sheet metal flashing and trim system. <br />1. Torch cutting of sheet metal flashing and trim is not permitted. <br />B. Metal Protection: Where dissimilar metals will contact each other or corrosive <br />substrates, .protect against galvanic action by painting contact surfaces with bituminous <br />coating or by other permanent separation as recommended by fabricator or <br />manufacturers of dissimilar metals. <br />1. Coat side of sheet metal flashing and trim with bituminous coating where flashing <br />and trim will contact wood, ferrous metal, or cementitious construction. <br />