2000-046 - Laserfiche WebLink

Home Browse Search

f Ir C> �bin paragraph 6.25.2 or 6.25.3 caused, directly or indirectly, in whole or in part, by CONTRAC"T"OR, and Subcontmetor, Supplier or any other person or organization directly or indirectly employed by any of them to perform or furnish any of the Work or anyone for whose acts any of them may be liable, shall be remedied by CONTRACTOR (except damage or loss attributable to the fault of Drawings or Specifications or to the acts or omissions of OWNER or ENGINEER or anyone employed by either of them or anyone for whose acts either of them may be liable, and not attributable, directly or indirectly, in whole or in part, to the fault or negligence ofCONTRACTOR). CONTRACTOR's duties and responsibilities for the safety and protection of the Work shall continue until such time as all the Work is completed and ENGINEER has issued a notice to OWNER and CONTRACTOR in accordance with paragraph 11.13 that the Work is acceptable (except as otherwise expressly provided in connection with Substantial Completion).. ® 6,26 CONTRACTOR shall desigate a responsible representative at the site whose duty shall be the prevention of accidents. This ,person shall be CON'TRACTOR's superintendent unless otherwise designated in writing by CONTRACTOR to OWNER, ® Emergencies: 6.27 In emergencies affecting the safety or protection of persons or the Work or property at the site or adjacent thereto, CONTRACTOR, without special instruction or authorization from ENGINEER or OWNER, is obligated to act to prevent threatened damage, injury or loss CONTRACTOR shall give ENGINEER prompt written notice that any significant changes in the Work or variations from the Contract Documents have been caused thereby. If ENGINEER determines that a change in the Contract Documents is required because of the action taken in response to an emergency, a''.'Vork Directive Change or Change Order will be issued to document the consequences of the changes or variations. Shop Drawings and Samples: 6.28 After checking and verifying all field measurements and after complying with applicable procedures specified in the General Requirements, CONTRACTOR shall submit to ENGINFMR for review in accordance with the accepted schedule of Shop Drawing submissions (see paragraph 2.9), or for other appropriate action if so indicated in the Supplementary Conditions, five (5) copies (unless otherwise specified in the General Requireinents) of all Shop Drawings, which will bear a Stamp or specific written indication that CONTRACTOR has satisfied CONTRACTOR's responsibilities under the Contract Documents with respect to the review of the submission. All submissions will be identified as LNGINVER may require. The data shown on the Shop Drawings will be complete with respect to quantities, dimensions, specified perfonnance and design criteria, materials and similar data to enable LNGINLER to review the information as required. 6.29 CONTRACTOR shall also submit to ENGINEER for review with such promptness as to cause nn delay in Work, all samples required by the Contract Documents. All samples will have been checked by and accompanied by a specific written indication that CON'T'RACTOR has salistied CONTRACTOR's responsibilities under the Contract Documents with respect to the review of the submission and will be identified clearly as to material, Supplier, pertincol Jaw such as catalog, numbers and the use for which intended. 6.30 Before submission of each Shop Drawing or sample CONTRACTOR shall have detennined and verified all quantities, dimensions, specified performance criteria, ttastallation requirements, materials, catalog numbers and similar data with respect thereto and reviewed or coordinated each Shop Drawing or sample with either Shop Drawings and samples and with the requirements of the Work and the Contract Documents. 6MURA1. t'ONPI MON!,' GC - 16