2000-236 - Laserfiche WebLink

Home Browse Search

40 4M �= OWNER and CONTRACTOR in accordance with paragraph 14.13 that the Work is acceptable �''� (except as otherwise expressly provided in connection with Substantial Completion). 626 CONTRACTOR shall designate a responsible representative at the site whose duty shall be the prevention of accidents. This person shall be CONTRACTOR's superintendent unless otherwise designated in writing by CONTRACTOR to OWNER. Emergencies: 6.27 In emergencies affecting the safety or protection of persons or the Work or property at the site or adjacent thereto, CONTRACTOR, without special instruction or authorization from ENGINEER or OWNER, is obligated to act to prevent threatened damage, injury or loss CONTRACTOR shall give ENGINEER prompt written notice that any significant changes in the Work or variations from the Contract Documents have been caused thereby. if ENGINEER determines that a change in the Contract Documents is required because of the action taken in response to an emergency, a Work Directive Change or Change Order will be issued to document the consequences of the changes or aj variations. Shop Drawings and Samples: 6.28 After checking and verifying all field measurements and alter complying with applicable procedures specified in the General Requirements, CONTRACTOR shall submit to ENGINEER for review in accordance with the accepted schedule of Shop Drawing submissions (see paragraph 2.9), or for other appropriate action if so indicated in the Supplementary Conditions, rive (5) copies (unless otherwise specified in the General Requirements) of all Shop Drawings, which will bear a stamp or specific written indication that CONTRACTOR has satisfied CONTRACTOR's responsibilities under the Contract Documents with respect to the review of the submission. All submissions will be identified as ENGINEER may require. The data shown on the Shop Drawings will be complete with respect to quantities, dimensions, specified performance and design criteria, materials and similar data to enable ENGINEER to review the information as required. 6.29 CONTRACTOR shall also submit to ENGINEER for review with such promptness as to cause no delay in Work, all samples required by the Contract Documents. All samples will have been checked by and accompanied by a specific written indication that CONTRACTOR has satisfied CONTRACTOR's responsibilities under the Contract Documents with respect to the review of the submission and will be idcritificd clearly as to material, Supplier, pertinent data such as catalog numbers and the use for which intended. 6.34 Before submission of each Shap Drawing or sample CONTRACTOR shall have determine(,] and verified all quantities, dimensions, specified performance criteria, installation requirements, materials, catalog numbers and similar data with respect thereto and reviewed or coordinated each Shop Drawing or sample with other Shop Drawings and samples and with the requirements of the Work and the Contract Documents. 6.31 At the time of each submission, CONTRACTOR shall give ENGINEER specific written notice: of each variation that the Shop Drawings or samples may have from the requirements of the Contract Documents, and in addition, shall cause a specific notation to be made on each Shop Drawing submitted to ENGINEER for review of each such variation. 6.32 ENGINEER will review with reasonable promptness Shop drawings and samples, but ENGINEER's review will be only for conformance with the design concept of the Traject and for compliance with the information given in the Contract Documents and shall not extend to means, methods, techniques, sequences or procedures of construction (except where a specific means, methods, technique, sequence or procedure of construction is indicated in or required by the Contract Documents) or to safety precautions or programs incident thereto. The review of a separate item as GENERAL CONDITIONS GC - 1 ti