Laserfiche WebLink
R NONCOMP <br />A. In addition to the OWNER's other remedies listed herein, if the CONTRACTOR <br />fails to comply with this Section and erosion or pollution is caused by <br />dewatering water or stormwater runoff from the construction site, the OWNER <br />will report the violations to the Indian River County Code Enforcement Board, <br />SJRWMD, Indian River Farms Water Control District (or other F. S. Chapter <br />298 Drainage District, as appropriate), and other pertinent regulatory or <br />enforcement agencies. <br />PART 2 - MATERIALS AND INSTALLATION <br />2.1 GENERAL <br />A. Staked Silt Fences: <br />1. General: Use silt fences to control runoff from the construction site <br />where the soil has been disturbed. <br />2. Installation: Install per the manufacture's recommendations and as <br />specified herein. In general, install the silt fence in a manner that allows <br />it to stop the water long enough for the sediment to settle while the water <br />passes through the silt fence fabric. All supporting posts shall be on the <br />down-slope side of the fencing. Place the bottom of the fabric 6 -inches <br />minimum, under compacted soil to prevent the flow of sediment <br />underneath the fence. Otherwise, install in accordance with FDOT Index <br />No. 102. <br />3, Removal: Contractor is responsible for removal of silt screens. <br />4. Product: All material shall be new and unused. Use FDOT Type IV silt <br />fences where large sediment loads are anticipated, where slopes are 1:2 <br />(vertical: horizontal) or steeper, or as directed by the ENGINEER; <br />otherwise use FDOT Type III silt fence. <br />(a) For FDOT Type III Silt Fence - ACF Environmental, Catalog No. <br />360800000, Florida DOT Silt Fence. U.S. Sieve = 30, tensile <br />strength = 120 pounds. The heavy-duty filter fabric shall be pre - <br />attached to 484ch long stakes on 6 -foot centers. (1-800448- <br />3636). <br />(b) For FDOT Type IV Silt Fence, modify the above Catalog No. <br />360800000 to comply with FDOT Index No. 102. <br />(c) Or equivalent. <br />B. Turbidity Barriers: <br />1. General: Use turbidity barriers to control sediment contamination of <br />rivers, lakes, ponds, canals, etc. <br />2. Installation: Install per the manufacturer's recommendations and per <br />FDOT Index No. 103 unless directed otherwise by the ENGINEER. <br />3, Removal: Contractor is responsible for disposal of turbidity barriers. <br />4. Product: All material shall be new and unused. The turbidity barrier shall <br />be a pervious barrier and the fabric color shall be yellow. <br />01025-8 Technical Specifications <br />FAEngineering\Capital Projects\0217-Powerline Road\Bid Documents\Technical Specifications.doc <br />