Laserfiche WebLink
Exhibit F / CUSTOMER REQUESTED STANDARD SOFTWARE ENHANCEMENTS / MODIFICATIONS <br /> AND / OR CUSTOM SOF'T'WARE <br /> (3) Programming and programming test. <br /> (4) On-site training, testing and/or other support services using Exhibit B rates and fees. <br /> For modification requiring over fifty (50) hours of work, New World utilizes a design document <br /> procedure [see 2(b)(/) below] . For smaller modifications, New World uses a Request For Service <br /> (RFS) procedure. Both procedures are reviewed with Customer at a pre-installation planning meeting. <br /> The RFS procedure utilizes a form with a narrative description and supporting documentation if <br /> applicable to define the work to be done. <br /> b) Implementation Schedule <br /> Activit Targeted Time Period <br /> (1) Complete Design Review or RFS Procedure with Customer To be determined <br /> Staff. Customer agrees to be reasonable and flexible in not <br /> attempting to design the modifications to be more extensive than <br /> called for in the scope (cost and schedule) of this project. <br /> (2) New World submits first draft of SSDD or RFS . To be determined <br /> (3) SSDD or RFS acceptance and sign-off by Customer (no To be determined <br /> programming will be done by New World until the formal sign- <br /> off and Customer's authorization to proceed in writing). <br /> (4) New World completes programming from SSDD or RFS and To be determined i <br /> provides modified software to Customer. <br /> (5) Software Modification Acceptance Test To be determined <br /> c) Customer' s Responsibility <br /> Customer' s responsibilities are additionally defined in Section 11, Paragraph 6.0 of the General Terms <br /> and Conditions of this Agreement. All Customer requested changes after design sign-off must be <br /> documented by Customer and authorized in writing including potential costs, if any. Additional <br /> changes will most likely delay the schedule and may increase the cost. <br /> 3. Cost and Pavment for Modifications <br /> The cost for the enhancements and/or custom software is to be paid as follows : <br /> a) DOWN PAYMENT $ 18,480 <br /> (60% - due upon execution of Agreement) <br /> b) FINAL PAYMENT 512,320 <br /> (40% - due upon installation of enhancements and/or custom software) <br /> TOTAL PAYMENTS DUE FOR EXHIBIT F .................................................................. 53Q <br /> Note : Where applicable, travel costs for New World employees to complete the tasks for Exhibit F services are <br /> billed under the provisions of Exhibit B services. All travel to be mutually agreed upon by Customer and <br /> New World. <br /> CONFIDENTIAL <br /> 3CNTADD Pre damm pawn spear map r3.doc Page 5 of 7 Indian River Co., FL <br />