Laserfiche WebLink
8 . 05 TOOLS AND SPARE PARTS <br /> A. Any special tools required shall be provided . <br /> B . The manufacturer shall furnish a complete set of recommended <br /> spare parts necessary for the first three (3) years of operation of <br /> the pumping system , which shall include at least the following : <br /> 1 . 1 — set of upper bearings <br /> 2 : 1 — set of lower bearings <br /> 3 . 1 — set of upper and lower shaft seals <br /> 4 . 1 —relay and phase monitor for each type supplied with the <br /> pump control panel for each station <br /> 5 . 1 — spare impeller (5 - spare impellers for Grinder Pumps ) <br /> 6 . 1 — PUC-001 pump control module for R . T. U . <br /> 7. 1 -- Back Pack Radio for TAC Pack <br /> C . Spare parts shall be properly bound and labeled for easy <br /> identification without opening the packaging , and suitably <br /> protected for long -term storage . <br /> 8 . 06 WARRANTY <br /> A. The Contractor and the equipment manufacturers shall warrant all <br /> equipment supplied under this section for a period of one ( 1 ) year. <br /> Warranty period shall commence on final date when the IRCDUS <br /> accepts the project . <br /> B . The equipment shall be warranted to be free from defects in <br /> workmanship , design and materials . If any part of the equipment <br /> should fail during the warranty period , it shall be replaced in the <br /> machine (s ) and the unit(s ) restored to service at no expense to <br /> the IRCOUS . <br /> C . The manufacturer's warranty period shall run concurrently with the <br /> Contractor's warranty period . No exception to the provision shall <br /> be allowed . <br /> 8 . 07 MATERIALS AND EQUIPMENT <br /> A. The pumping units required under this section shall be complete , <br /> including pumps and motors with proper alignment and balancing <br /> of the individual units . All parts shall be so designed and <br /> proportioned as to have liberal strength , stability,. and stiffness , <br /> and to be especially adapted for the work to be done . Ample <br /> room shall be provided for inspection , repairs , and adjustments . <br /> B . Each foundation plate for each pump shall be rigidly and <br /> accurately anchored into position . The same pump manufacturer <br /> 8 - 3 <br />