Laserfiche WebLink
C. <br />4) American Water Works Association (AWWA) <br />a) AWWA C906 — Polyethylene (PE) Pressure Pipe and Fittings, 4 in. through 63 <br />in., for water distribution <br />Quality Assurance <br />1) Quality <br />All materials shall be new and properly manufactured, and shall conform to the <br />requirements of any referenced standards. All materials shall be standard first -grade <br />quality produced by expert workmen and be intended for the use for which they are <br />offered. Materials which, in the opinion of the ENGINEER, are inferior or of a <br />lower grade than indicated, specified or required will not be acceptable. <br />2) Source Limitations <br />To the greatest extent possible for each unit of Work, the CONTRACTOR shall <br />provide products, materials, or equipment of a singular generic kind from a single <br />source. <br />3) Compatibility of Options <br />Where more than one choice is available as options for CONTRACTOR'S selection <br />of a product, material, or equipment, the CONTRACTOR shall select an option, <br />which is compatible with other products and materials already selected. <br />Compatibility is a basic general requirement of product/material selections. <br />4) CONTRACTOR/INSTALLER (C/I) Qualifications <br />For a C/I to be considered as an acceptable C/I, the C/I must have had at least three <br />(3) years active experience in the commercial installation of directional bored <br />polyethylene pipe and must have installed a minimum of 10,000 linear feet or 20 <br />sections of successful large diameter (12" or greater) polyethylene pipe installations <br />in the United States. <br />To be acceptable, the C/I shall hold an active CERTIFIED or REGISTERED <br />UNDERGROUND UTILITIES CONTRACTOR LICENSE with the State of <br />Florida Department of Professional Regulation Construction Industry Licensing <br />Board. A copy of the CERTIFIED UNDERGROUND UTILITIES CONTRACTOR <br />LICENSE shall be submitted prior to excavation. <br />5) Right of Rejection <br />The ENGINEER or the OWNER, shall have the right, at all times and places, to <br />reject any articles or materials to be furnished hereunder which, in any respect, fail <br />to meet the requirements of the Contract Documents, regardless of whether the <br />defects in such articles or materials are detected at the point of manufacture or after. <br />completion of the Work at the site. <br />02400 — Directional Bore Crossings <br />02400 - 2 <br />