Laserfiche WebLink
Provide concrete bases of dimensions indicated, except in bedrock. Compact concrete to <br />eliminate voids, and finish to a dome shape. In bedrock, set posts with a minimum of one <br />inch of grout around each post. Work grout into hole to eliminate voids, and finish to a dome <br />shape. <br />D. Concrete Slabs and Walls <br />Set posts into zinc -coated sleeves, set in concrete slab or wall, to a minimum depth of 12 <br />inches. Fill sleeve joint with lead, non -shrink grout, or other approved material. Set posts <br />for support of removable fence sections into sleeves that provide a tight sliding joint and hold <br />posts aligned and plumb without use of lead or setting material. <br />E. Bracing <br />Brace gate, corner, end, and pull posts to nearest post with a horizontal brace used as a <br />compression member, placed at least 12 inches below top of fence, and two diagonal truss <br />rods and truss tighteners used as tension members. <br />F. Top Rail <br />Install top rails before installing chain-link fabric. Pass top rail through intermediate post <br />caps. Provide expansion coupling spaced as indicated. <br />G. Bottom Tension Wire <br />Install bottom tension wires before installing chain-link fabric, and pull wires taut. Place top <br />and bottom tension wires within 8 inches of respective fabric line. <br />H. Fabric <br />Pull fabric taut and secure fabric to top rail and bottom rail and top wire and bottom wire, <br />close to both sides of each post and at maximum intervals of 24 inches on center. Secure <br />fabric to posts using stretcher bars, ties or clips spaced 15 inches on center, or by integrally <br />weaving to integral fastening loops of end, corner, pull, and gate posts for full length of each <br />post. Install fabric on opposite side of posts from area being secured. Install fabric so that <br />bottom of fabric is 2 inches above ground level. Install fence fabric to provide <br />approximately 2 inch deflection at center of fabric span between two posts, when a force of <br />approximately 30 pounds is applied perpendicular to fabric. Fabric should return to its <br />original position when force is removed. <br />3.03 ACCESSORY INSTALLATION <br />A. Post Caps <br />Design post caps to accommodate top rail. Install post caps as recommended by the <br />manufacturer. <br />B. Gates <br />Install swing gates to swing through 180 degrees from closed to open. Install sliding <br />cantilever gates to clear the opening dimension(s) shown on plans. <br />02821 — Chain Link Fence and Gates <br />02821 - 6 <br />