Laserfiche WebLink
D. Form work true to line and level with accurate angles and surfaces. <br />E. Fabricate connections that will be exposed to weather in a manner to exclude water. Provide weep holes <br />where water may accumulate. <br />F. Cut, reinforce, drill, and tap as indicated to receive finish hardware, screws, and similar items. <br />G. Connections: Fabricate railings with [welded] connections unless otherwise indicated. <br />H. Welded Connections: Cope components at connections to provide close fit, or use fittings designed for <br />this purpose. Weld all around at connections, including at fittings. <br />1. Use materials and methods that minimize distortion and develop strength and corrosion resistance <br />of base metals. <br />2. Obtain fusion without undercut or overlap. <br />3. Remove flux immediately. <br />4. At exposed connections, finish exposed surfaces smooth and blended so no roughness shows after <br />finishing and welded surface matches contours of adjoining surfaces. <br />I. Form changes in direction as follows: <br />1. By bending. <br />J. Bend members in jigs to produce uniform curvature for each configuration required; maintain cross <br />section of member throughout entire bend without buckling, twisting, cracking, or otherwise deforming <br />exposed surfaces of components. <br />K. Close exposed ends of railing members with prefabricated end fittings. <br />L. Provide wall returns at ends of wall -mounted handrails unless otherwise indicated. Close ends of returns <br />unless clearance between end of rail and wall is 1/4 inch (6 mm) or less. <br />M. Brackets, Flanges, Fittings, and Anchors: Provide wall brackets, flanges, miscellaneous fittings, and <br />anchors to interconnect railing members to other work unless otherwise indicated. <br />N. Provide inserts and other anchorage devices for connecting railings to concrete or masonry work. <br />Fabricate anchorage devices capable of withstanding loads imposed by railings. Coordinate anchorage <br />devices with supporting structure. <br />2.7 FINISHES, GENERAL <br />A. Comply with NAAMM's "Metal Finishes Manual for Architectural and Metal Products" for <br />recommendations for applying and designating finishes. <br />B. Protect mechanical finishes on exposed surfaces from damage by applying a strippable, temporary <br />protective covering before shipping. <br />Wabasso Beach Park 05521-5 <br />Indian River County <br />DAA Project No. 6008 <br />