Laserfiche WebLink
560-2 Materials . <br /> 560-2 . 1 Coating System : Use only coating products and systems meeting the <br /> requirements of Section 975 and listed on the Departments Qualified Products List (QPL) . <br /> Use Type M coal tar epoxy coatings meeting the requirements of Section 926 and <br /> listed on the Department ' s QPL for coating of permanent bulkhead sheet piles and H piles . <br /> 560-2 .2 Thinners, Solvents and Cleaners : Use thinners , solvents and cleaners listed on <br /> the coating manufacturer ' s product data sheet . <br /> 560-2 .3 Caulking : Use caulks that are paintable, compatible with the coating system and <br /> recommended by the coating manufacturer as part of the coating system . <br /> 560-2 .4 Soluble Salts Test Kit : Use a soluble salts test kit in accordance with <br /> SSPC -Guide 15 utilizing a Class A retrieval method. Ensure the test sleeve or cell creates a <br /> sealed, encapsulated environment during ion extraction and is suitable for testing all structural <br /> steel surfaces . <br /> 560-2 .5 Abrasives : Use properly sized abrasives to achieve the required cleanliness and <br /> anchor profile . Use abrasives meeting the requirements of SSPC -AB 1 , Mineral and Slag <br /> Abrasives , SSPC -AB 2 , Cleanliness of Recycled Ferrous Metallic Abrasives , or SSPC -AB 3 , <br /> Newly Manufactured or Re-Manufactured Steel Abrasive and do not introduce any <br /> contamination that interferes with the coating application and performance . <br /> Provide certification to the Engineer that the abrasives used meet the requirements <br /> of this Section and do not contain any chlorides and other salts . <br /> For recycled abrasives , verify compliance with the conductivity and cleanliness <br /> requirements of SSPC -AB 2 after each recycling or more frequently if required by the Engineer. <br /> Select a sample from each recycling machine in use and conduct the water- soluble contaminant <br /> and oil content tests outlined in SSPC -AB 2 at least one time each week or more frequently if <br /> directed by the Engineer. Conduct the non- abrasive residue and lead content tests as directed by <br /> the Engineer. If test results do not meet requirements , notify the Engineer immediately, remove <br /> and replace the abrasive , clean the recycling equipment , and conduct tests each day to confirm <br /> the equipment is functioning properly. Return to the weekly testing interval as directed by the <br /> Engineer. <br /> 560-2 . 6 Rust Preventative Compound : Use a Class 3 rust preventative compound <br /> meeting the requirements of Military Specification MIL-C4 1796C , Corrosion Preventative <br /> Compound, Petrolatum, Hot Applied. <br /> 560-2 . 7 Storage : Store materials in conformance with the manufacturer ' s <br /> recommendations . <br /> 560-3 Equipment. <br /> 560-3 . 1 Compressed Air : Use a compressed air system capable of delivering clean, dry, <br /> continuous nozzle pressure to achieve the required surface cleanliness and profile or spray <br /> pattern . The system must comply with the instructions and recommendations of the manufacturer <br /> of the abrasive blasting system or coating application system . <br /> 560-3 . 2 Abrasive Blasting System : Design the blasting system to produce the specified <br /> cleanliness and profile . <br /> 560-3 .3 Coating Application System : Use the coating application equipment approved <br /> by and in accordance with the Coating Manufacturer ' s technical data requirements . <br /> - 161 - <br /> FPID ( S ) : 4231864 - 58 -01 <br /> WWI <br /> G " <br /> , : , <br />