2011-226B.1 - Laserfiche WebLink

Home Browse Search

% IN I ` . , . , . rr ; °, .z , 1 . k1 ,# s ,✓ r�,a "`z. ..,. x S a to '' 'r P ,` % r, .a" .ra 4 ,� c t . ; .�` � ,. .. I- „ � , . a �� — ` 560.4 Environmental, Health and Safety Requirements . Isolate the work areas with containment devices , canvasses , tarpaulins or screens during all surface preparation and coating application operations . Dispose of all debris and waste products generated in accordance with all Federal, State and Local regulations . 560-5 Quality Control. 560-5 . 1 Shop Preparation and Application : Prior to applying coatings , provide a current Corporate Quality Control Plan approved by the American Institute of Steel Construction (AISC) under the Sophisticated Paint Endorsement program or SSPC under the SSPC -QP3 certification to the State Materials Office for approval . 560-5 . 2 Field Preparation and Application : Provide a current Corporate Quality Control Plan approved by SSPC under the SSPC -QP1 and/or SSPC -QP2 certifications as appropriate and a site specific Coating Quality Control Plan to the Engineer at least 14 calendar days prior to beginning coatings work. Do not begin coatings work until the site specific Coating Quality Control Plan has been approved by the Engineer. 560-5 .3 Inspection : Ensure that all inspection equipment is maintained in accordance with the manufacturer' s instructions , calibrated, and in good working condition. Ensure that all activities are observed and approved by a quality control coatings inspector meeting the requirements of this Section . Maintain daily inspection reports at the job site for review by the Engineer. Provide all daily inspection reports upon completion of the project to the Engineer or more frequently as requested by the Engineer. 560-6 Qualifications . 560-6 . 1 Shop : Provide documentation to the Engineer at least 14 days prior to beginning work that the shop performing any work in accordance with this Section is certified by AISC Sophisticated Paint Endorsement or by SSPC to the requirements of SSPC - QP3 . 560-6.2 Field Contractor : Provide documentation to the Engineer at least 14 days prior to beginning work that the field contractor performing any work in accordance with this Section is certified by SSPC to the requirements of SSPC - QP1 and/or SSPC - QP2 as appropriate . 560-6.3 Quality Control Inspectors in the Shop and Field : Provide documentation to the Engineer that all personnel performing quality control inspections are certified at a minimum as a National Association of Corrosion Engineers (NACE) Coating Inspector Level I or a SSPC Level 1 Bridge Coating Inspector and that they report directly to a Quality Control Supervisor who is certified either as a NACE Coating Inspector Level 3 or a SSPC Level 2 Bridge Coating Inspector. 560-6.4 Certifications : Maintain certifications for the duration of the Contract . If the certifications expire, do not perform any work until certifications are reissued. Notify the Engineer of any change in certification status . 560-7 Surface Preparation. 560-7 . 1 General : Ensure all surfaces to be coated are clean , dry, and free from oil , grease , dirt, dust, soluble salts , corrosion, peeling coating, caulking, weld spatter, mill scale and any other surface contaminants . Prepare all surfaces that will become inaccessible after fabrication, erection, or installation while accessible . Sequence the surface preparations and coating operations so that freshly applied coatings will not be contaminated by dust or foreign matter. Protect all equipment and adjacent surfaces not to be coated from surface preparation operations . Protect working mechanisms against intrusion of abrasive . In the event that any 462 - FPID ( S ) : 62 - FPID ( S ) : 4231864 - 58 -01 r Ass A At