2011-226B.1 - Laserfiche WebLink

Home Browse Search

i < The Department will base payment for equipment furnished under purchase f " contracts on satisfactory completion of the visual inspection and operational tests required by 611 - 7 . 1 . � Before any payment will be made for each functional group , deliver to the Engineer and receive from the Engineer acceptance of all units of each functional group of equipment required to be furnished by the Contract Documents . The Department will make It I separate payment for a staged delivery of each functional group of equipment only when staged delivery is specified in the Contract Documents . 611 -7.3 Equipment Failing to Pass Acceptance Tests : When any unit of equipment fails to pass the acceptance tests , correct the deficiencies (by repair or replacement) , at no expense (including all freight costs) to the Department, to attain compliance . If the original Contract Time has expired, the Department will charge and continue to assess liquidated damages in accordance with 8 - 10 until final acceptance of the equipment. Upon compliance with such correction requirements , the Engineer will perform tests on the equipment as specified above and will determine their eligibility for payment. } The Department will not assess liquidated damages during the acceptance test period in 611 - 7 . 1 . The Department will allow only one acceptance test exclusion with regard to liquidated damages assessment per lot of units required to be delivered. 635 PULL AND JUNCTION BOXES . (REV 7-2840) (FA 8-340) (1 - 11 ) ARTICLE 635 - 3 (Page 749) is deleted and the following substituted : 635-3 Pull Boxes Installation . Install pull boxes in accordance with the Design Standards , Index No . 17700 . Ensure that the pull box cover is flush with the finished grade or sidewalk. Do not install pull boxes in roadways , driveways , parking areas, ditches or public sidewalk curb ramps . 650 VEHICULAR SIGNAL ASSEMBLIES — INSTALLATION . (REV 647-09) (FA 648-09) (1 - 10) SUBARTICLE 650 - 3 . 7 (Page 761 ) is deleted and the following substituted : 650-3 . 7 Vertically Mounted Polycarbonate (Light-Weight) Signal Head Assemblies : The top section of all multi- section ( 5 - section, 3 - section) , vertically mounted, light- weight signal heads must be constructed of die cast aluminum, unless the entire 3 - section polycarbonate signal head assembly is specifically approved and listed on the APL as a 12" Polycarbonate 3 - Section Vehicle Assembly. Ensure that all sections of multi - section assemblies are from the same manufacturer. Single section signals may be constructed of die cast aluminum or polycarbonate construction . - 179 - FPID ( S ) : 423186 - 1 - 58 -01 t