Laserfiche WebLink
el <br /> ev <br /> —5 Al I <br /> WV <br /> - "'t —d a:, Y § ' CY,�' Wee . $ < § a3 .f. i <br /> e Ile <br /> C . Cement and lime shall be stored under a roof and off the ground and shall be kept <br /> completely dry at all times . All structural , miscellaneous and reinforcing steel shall be <br /> stored off the ground or otherwise to prevent accumulations of dirt or grease and in a <br /> position to prevent accumulations of standing water and to minimize rusting . Beams shall <br /> be stored with the webs vertical . Precast concrete shall be handled and stored in a manner <br /> to prevent accumulations of dirt, standing water, staining, chipping or cracking . Brick, <br /> block and similar masonry products shall be handled and stored in a manner to reduce <br /> breakage, cracking and spalling to a minimum . <br /> D . All mechanical and electrical equipment and instruments subject to corrosive damage by <br /> the atmosphere if stored outdoors (even though covered by canvas) shall be stored in a <br /> weathertight building to prevent injury . The building may be a temporary structure on the <br /> site or elsewhere, but it must be satisfactory to the Resident Project Representative . <br /> Building shall be provided with adequate ventilation to prevent condensation . Maintain <br /> temperature and humidity within range required by manufacturer. <br /> 1 . All equipment shall be stored fully lubricated with oil , grease and other <br /> lubricants unless otherwise instructed by the manufacturer . <br /> 2 . Moving parts shall be rotated a minimum of once weekly to ensure proper <br /> lubrication and to avoid metal -to-metal " welding " . Upon installation of the <br /> equipment, the Contractor shall start the equipment, at least half load, once <br /> weekly for an adequate period of time to ensure that the equipment does not <br /> deteriorate from lack of use . <br /> 3 . Lubricants shall be changed upon completion of installation and as frequently as <br /> required thereafter during the period between installation and acceptance . New <br /> lubricants shall be put into the equipment at the time of acceptance . <br /> 4 . Prior to acceptance of the equipment, the Contractor shall have the manufacturer : <br /> inspect the equipment and certify that its condition has not been detrimentally 1 <br /> affected by the long storage period. Such certifications by the manufacturer shall ' <br /> be deemed to mean that the equipment is judged by the manufacturer to be in a <br /> condition equal to that of equipment that has been shipped, installed, tested and <br /> accepted in a minimum time period. As such , the manufacturer will guaranty the <br /> equipment equally in both instances . If such a certification is not given , the <br /> equipment shall be judged to be defective . It shall be removed and replaced at the t <br /> Contractor' s expense . <br /> END OF SECTION <br /> li <br /> • <br /> 01600 -2 <br />