2013-086 - Laserfiche WebLink

Home Browse Search

PART B - DAILY SAMPLE RESULTS Monitoring Period: Enter the month, day, and year for the first and last day of the monitoring period (i.e. the month, the quarter, the year, etc.) during which the data on this report were collected and analyzed. Daily Monitoring Results: Transfer all analytical data from your facility's laboratory or a contract laboratory's data sheets for all day(s) that samples were collected. Record the data in the units indicated. Table 1 in Chapter 62. 160, F.A.C., contains a complete list of all the data qualifier codes that your laboratory may use when reporting analytical results. However, when transferring numerical results onto Part B of the DMR, only the following data ualifier codes should be used and an explanation provided where appropriate. CODE DESCRIPTION/INSTRUCTIONS < The compound was analyzed for but not detected. A Value reported is the mean (average) of two or more determinations. J Estimated value value not accurate. Sample held beyond the actual holding time. Y Laboratory analysis was from an unpreserved or improperly preserved sample. Add the results to get the Total and divide by the number of days in the month to get the Monthly Average, Plant Staffing: List the name, certificate number, and class of all state certified operators operating the facility during the monitoring period. Use additional sheets as necessary. PART D - GROUND WATER MONITORING REPORT Monitoring Period: Enter the month, day, and year for the first and last day of the monitoring period (i.e, the month, the quarter, the year, etc.) during which the data on this report were collected and analyzed. Date Sample Obtained: Enter the date the sample was taken. Also, check whether or not the well was purged before sampling. Time Sample Obtained: Enter the time the sample was taken Sample Measurement: Record the results of the analysis. If the result was below the minimum detection limit, indicate that. Detection Limits: Record the detection limits of the analytical methods used. Analysis Method: Indicate the analytical method used. Record the method number from Chapter 62460 or Chapter 62-601 , F.A.C., or from other sources. Sampling Equipment Used: Indicate the procedure used to collect the sample (e.g. airlift, bucket/bailer, centrifugal pump, etc.) Samples Filtered: Indicate whether the sample obtained was filtered by laboratory (L), filtered in field (F), or unfiltered (N). Signature: This report must be signed in accordance with Rule 62-620.305, F.A.C. Type or print the name and title of the signing official. Include the telephone number where the official may be reached in the event there are questions concerning this report. Enter the date when the report is signed. Comments and Explanation: Use this space to make any comments on or explanations of results that are unexpected. If more space is needed, reference all attachments in this area. SPECIAL INSTRUCTIONS FOR LIMITED WET WEATHER DISCHARGES Flow (Limited Wet Weather Discharge): Enter the measured average flow rate during the period of discharge or divide gallons discharged by duration of discharge (converted into days). Record in million gallons per day (MGD). Flow (Upstream): Enter the average flow rate in the receiving stream upstream from the point of discharge for the period of discharge. The average flow rate can be calculated based on two measurements; one made at the start - — -- - --and. one-made at the end of-the.discharge period. Measurements are to be made at-the upstream gauging station described in thepermit - Actual Stream Dilution Ratio: To calculate the Actual Stream Dilution Ratio, divide the average upstream flow rate by the average discharge flow rate. Enter the Actual Stream Dilution Ratio accurate to the nearest 0. 1 . Na of Days the SDF > Stream Dilution Ratio: For each day of discharge, compare the minimum Stream Dilution Factor (SDF) from the permit to the calculated Stream Dilution Ratio, On Part B of the DMR, enter an asterisk (•) if the SDF is greater than the Stream Dilution Ratio on any day of discharge. On Part A of the DMR, add up the days with an "e" and record the total number of days the Stream Dilution Factor was greater than the Stream Dilution Ratio, CBOD,: Enter the average CBOD, of the reclaimed water discharged during the period shown in duration of discharge. TKN: Enter the average TKN of the reclaimed water discharged during the period shown m duration of discharge. Actual Rainfall: Enter the actual rainfall for each day on Part B. Enter the actual cumulative rainfall to date for this calendar year and the actual total monthly rainfall on Part A. The cumulative rainfall to date for this calendar year is the total amount of rain, m inches, that has been recorded since January 1 of the current year through the month for which this DMR contains data. Rainfall During Average Rainfall Year. On Part A, enter the total monthly rainfall dining the average rainfall year and the cumulative rainfall for the average rainfall year. The cumulative rainfall for the average rainfall year is the amount of rain, in inches, which fell during the average rainfall year from January through the month for which this DMR contains data. No. of Days LW WD Activated During Calendar Year. Enter the cumulative number of days that the limited wet weather discharge was activated since January 1 of the current year. Reason for Discharge: Attach to the DMR a brief explanation of the factors contributing to the need to activate the limited wet weather discharge. DEP Fomf 62-QO.910(10), dreWve November 29, 1994 I