Laserfiche WebLink
1.7 PENALTIES FOR NONCOMPLIANCE WITH THIS SECTION <br /> A. In addition to the OWNER's specific remedies, if erosion or pollution is caused by <br /> dewatering water or stormwater runoff from the construction site, the OWNER may <br /> report the violations to Indian River County Stormwater Enforcement, SJRWMD, <br /> FDEP, Indian River Farms Water Control District(or other F. S. Chapter 298 Drainage <br /> District, as appropriate), and other pertinent regulatory or enforcement agencies. <br /> PART 2 - MATERIALS AND INSTALLATION <br /> 2.1 GENERAL <br /> A. Polyacrylamide:As required in Paragraph 1.3.C, place polyacrylamide (PAM)on bare <br /> ground to reduce the potential for erosion and cover it with hay, jute, or mulch. PAM <br /> may also be used in water bodies to remove turbidity. In all cases, use the anionic <br /> form of polyacrylamide that does not stick to fish gills. For PAM information and its <br /> proper application, a contact is Applied Polymer Systems, Inc., (678) 494-5998, <br /> www.siltstop.com. <br /> B. Staked Silt Fences: <br /> 1. General: Use silt fences to control runoff from the construction site where the <br /> soil has been disturbed. <br /> 2. Installation: Install per the manufacture's recommendations and as specified <br /> herein. In general, install the silt fence in a manner that allows it to stop the <br /> water long enough for the sediment to settle while the water passes through the <br /> silt fence fabric. All supporting posts shall be on the down-slope side of the <br /> fencing. Place the bottom of the fabric 6-inches minimum, under compacted <br /> soil to prevent the flow of sediment underneath the fence. Place silt fences <br /> away from the toe of slopes. Otherwise, install in accordance with FDOT Index <br /> No. 102. <br /> 3. Product:All material shall be new and unused. Use FDOT Types III through IV <br /> silt fences where large sediment loads are anticipated, where slopes are 1:2 <br /> (vertical: horizontal) or steeper, or as directed by the ENGINEER; otherwise use <br /> FDOT Type II silt fence. <br /> C. Turbidity Barriers: <br /> 1. General: Use turbidity barriers to control sediment contamination of <br /> rivers, lakes, ponds, canals, etc. <br /> 2. Installation: Install per the manufacturer's recommendations and per FDOT <br /> Index No. 103 unless directed otherwise by the ENGINEER. <br /> 3. Product: All material shall be new and unused. The turbidity barrier shall be a <br /> pervious barrier and the fabric color shall be yellow. Use staked turbidity <br /> barriers in water less than one-foot deep. Use floating turbidity barriers in water <br /> one-foot or deeper. <br /> 01025-17 Technical Specifications <br /> F:\Public Works\ENGINEERING DIVISION PROJECTS\1425-S County Park-General Use Field\Admin\bid documents\Master Contract <br /> Documents\Technical Specifications.doc <br />