2018-044A - Laserfiche WebLink

Home Browse Search

and specifications. The Owner and Engineer shall have the authority to judge the quality and require replacement of unacceptable work or personnel at any time. B. All contractors shall cooperate in the execution of their work and shall. plan their work in such manners as to avoid conflicting schedules or delay. of work. If any part of a Con- tractor's work depends upon the work of another Contractor, defects, which may affect that work;'shall be reported to the Engineer in order that prompt inspection may be made and defects corrected. Commencement of work by a Contractor where such condition ex- ists xists will constitute acceptance of the other Contractor's work as being satisfactory in all respects to receive the work commenced, except defects, which may! later develop. Work of all trades under this contract shall be closely coordinated in such a manner as to obtain the best possible workmanship for the entire project. All components of the work shall be installed in accordance with the best practices of the particular trade. The Gen- eral eneral Contractor is responsible to advise the Owner sufficiently in advance of operations to allow for assignment of personnel. C. Materials or methods described by words which, when applied, have a well-known tech- nical or trade meaning will be held to refer to such recognized standard. Standard speci- fications or manufacturer's literature, when referenced, shall be of the latest revision or printing unless otherwise stated, and are intended to establish the minimum requirements acceptable, D. All materials shall be new, all materials and workmanship shall be in every respect in ac- cordance with the best modem practice. E. When special makes or grades of material which are normally packaged by the supplier or manufacturer are specified or accepted, such materials shall be delivered to the site in . original packages or containers with seals unbroken and labels intact and shall not be opened until inspected and approved by the Engineer. Contractor shall notify the Engi- neer prior to such material's delivery. F. The Contractor's Foreman or Superintendent to maintain one complete set of the contract documents and approved submittals on the job site. G. Contractor shall be responsible to correct deficiencies identified by Engineer and non- conforming onconforming work within 24 hours of receipt of notification, either verbally or. written, and submit a plan of action for addressing the deficiencies and non -conforming work. Fur- ther tear -off or commencement of other, work shall not occur until all deficiencies and non -conforming work are properly addressed. H. Installer Qualifications: A firm or individual experienced in installing, erecting, or as- sembling work similar in material, design, and extent to that.indieated for this Project, . whose work has resulted in construction with a record of successful in-service perfor- mance. 1. Acceptable Contractor: a. Be certified in writing for a minimum of two years by the roofing mate- rials manufacturer to install the primary roofing products. b. Be recognized in the commercial roofing industry. C. Have a minimum of -five (5) years' experience in installing the same or the same firm name as that, submitting • similar materials specified under the bid. If requested, submit a copy of firm's Articles of Incorporation to verify years in business. Also all crew workers on site are to be experl- Indian River County Health Department Roof Replacement & Exterior Repair 014000-2 Quality Requirements