Laserfiche WebLink
E. Curb Inlet Protection: <br />1. Filter stormwater before it enters curb inlets. <br />2. Installation: Install in accordance with the manufacturer's specifications. <br />Use as many of the specified filtration devices as required, at no additional <br />cost to the OWNER. <br />'3. Product: All materials shall be new and unused. The length of the curb inlet <br />filtration device shall be at least 2 -feet longer than the curb inlet opening. <br />a. "GUTTERBUDDY," supplied by ACF Environmental, Inc. (1-800- <br />448-3636). <br />b. Or equivalent. <br />F. Catch Basin Protection: <br />1. Filter stormwater before it enters catch basins (drop inlets). The filter "sack" <br />shall be manufactured from woven polypropylene geotextile and sewn by a <br />double -needle machine, using a high strength nylon thread. The sack shall <br />be manufactured to fit the opening of the catch basin or drop inlet and it <br />shall have the following features: two dump straps attached at the bottom <br />to facilitate emptying; lifting loops as an integral part of the system to be <br />used to lift the sack from the basin; and a colored restraint chord <br />approximately halfway up the sack to keep the sides away from the catch <br />basin walls. The colored restraint chord shall also serve as a visual means <br />of indicating when the sack should be emptied. <br />2. Installation: Install in each catch. basin in accordance with the <br />manufacturer's specifications. Use as many of the specified filtration <br />devices as required, at no additional cost to the OWNER. <br />3. Product: All materials shall be new and unused. <br />a. "SILTSACK" (regular flow), supplied by ACF Environmental, Inc. (1- <br />800-448-3636). <br />b. "FloGuard+PLUS," supplied by Kristar Enterprises, Inc. (1-800-579- <br />8819). <br />C. Or equivalent. <br />G. Construction Site Egress Driveways: Minimize the transport of sediment and soil <br />from the construction site or work area by vehicle wheels. Construct a crushed <br />rock driving surface at the vehicle exit point(s). Locate the site egress driveways <br />a minimum of 25 feet from all drainage inlets or pipes. Provide an area large <br />enough to remove the sediment and soil from vehicle wheels before the vehicle <br />leaves the construction site or work area.. Provide wash -down stations as required <br />to wash vehicle tires and retain all washwater on-site. Do not use limerock. <br />H. Rock and Stone for Erosion Control and Pollution Control and Treatment: <br />1. Crushed Limerock: Limerock shall not be used under any <br />circumstance. <br />2. Acceptable Material: FDOT #4 non -calcareous aggregate, washed and <br />meeting the requirements of FDOT Standard Specifications for Road and <br />Bridge Construction, Section 901. <br />I. Hay Bales: Hay bales shall not be used. <br />01025-9 Technical Specifications <br />FAPublic Works\ENGINEERING DIVISION PROJECTS\1305-CR 512 Resurf (SCOP)_Myrtle St to 125th St\Admim\bid_ <br />documents\Master Contract Documents\Technical Specifications - 100% Submittal - Rev 02 11-06-17.docx <br />