Laserfiche WebLink
5. American National Standard <br /> a. ANSI/SPRI ES-1 Wind Design Standard for Edge Systems Used with <br /> Low Slope Roofing Systems <br /> 6. Underwriters Laboratories, Inc. (UL) <br /> 7. FM Global/Factory Mutual Research(FM) <br /> 1.04 DEFINITIONS <br /> A. Rough Carpentry includes carpentry work not specified as part of other Sections and <br /> generally not exposed. <br /> B. KDAT:Kiln Dried After Treatment. <br /> 1.05 SUBMITTALS <br /> A. Refer to Section 01 33 00-Submittal Procedures for Submittals. <br /> B. Manufacturer's Product Data Sheets for all materials specified certifying material <br /> complies with this specification. <br /> 1.06 QUALITY ASSURANCE <br /> A. Contractor shall inspect wood to be installed for damage, warping, splits, and moisture <br /> content as defined by the applicable wood products industry standards. Materials that do <br /> not comply shall be rejected. <br /> B. Rough carpentry installation shall present a smooth, consistent substrate for roof system <br /> and flashing installation. <br /> C. Qualifications of workers: Provide sufficient, competent and skilled carpenters in <br /> accordance with accepted practices and supervisors who shall be present at all times <br /> during execution of this portion of the work, and who shall be thoroughly familiar with <br /> type of construction involved in this section and related work and techniques specified. <br /> D. Moisture Content: <br /> 1. Treated wood products shall be KDAT. <br /> 2. Treated lumber used in the roofing assembly shall not be stored or installed in a <br /> manner exposing it to rain. <br /> 3. Moisture content of treated lumber shall be 19 percent or less before being <br /> covered/enclosed into roofing assembly. <br /> 4. Contractor shall be responsible for ensuring lumber is delivered, stored and <br /> installed at 19%or less moisture content. <br /> 5. Plywood shall be 18% or less before being covered/enclosed into roofing <br /> assembly. <br /> E. Each piece of treated lumber and plywood shall bear the stamp of the AWPA Quality <br /> Mark, indicating compliance with the requirements of the AWPA Quality Control <br /> Program. <br /> F. Lumber Standards: Comply with PS 20 and applicable rules of respective grading and <br /> inspecting agencies for species and products indicated. <br /> Sebastian Corners Roof Replacement 06 10 00-2 Rough Carpentry <br />