Laserfiche WebLink
Page 7 of 8 <br />M-10 - Valve Marker. This drawing has been re -numbered from M-9 to M-10. A pipe detail has been added <br />to the Elevation View with a Note "Place over pipe at valve location". The drawing has been revised with <br />the inclusion of a Plan View to illustrate the orientation of the valve marker, which is to be placed <br />perpendicular to roadway. Note 1 has been added regarding marker to be placed perpendicular to the <br />roadway. <br />M-11 - Jack and Bore Detail Casing Insulator/Spacer. This drawing has been re -numbered from M-10 to <br />M-11. <br />M-12 - Casing Installation Details. This drawing has been re -numbered from M-11 to M-12. <br />M-13 - Jack and Bore Casing Vent & End Seal Detail. This drawing has been re -numbered from M-12 to <br />M-13. <br />M-14 - Trace Wire Details. This drawing has been re -numbered from M-13 to M-14. The trench sketch in <br />the Plan View has been deleted. The meter box has been revised from a pre -plumbed (enclosed) box to <br />an open bottom meter box. <br />M-15 - As -Built Record Drawing (Example). This drawing has been re -numbered from M-14 to M-15. <br />M-16 - As -Built Record Drawing General Notes. This drawing has been re -numbered from M-15 to M-16. <br />Note 9 has been incorporated into Note 8. The following change was inserted into Drawing M-16, As -Built <br />Record Drawings, Note 9. Electronic copies of record drawings shall be formatted with all newly <br />constructed IRCDUS utilities in the following AutoCad layer states: <br />AUTOCAD LAYER NAME <br />IRCDUS UTILITY <br />WATER <br />WATER MAINS, WATER VALVES, HYDRANTS, WATER <br />SERVICE LINES AND WATER METERS <br />SEWER <br />SEWER FORCE MAINS, SEWER VALVES, GRAVITY <br />SEWER, SEWER SERVICE LINES <br />R/O CONCENTRATE (BRINE) <br />R/O CONCENTRATE MAINS, R/O VALVES <br />RECLAIMED WATER <br />RECLAIMED WATER MAINS, RECLAIMED WATER <br />VALVES <br />M-16 A - As -Built Record Drawing Notes (Continued). This drawing has been re -numbered from M-16 to <br />M-16 A. The General Notes are continued from M-16. <br />M-17 - Route Survey Requirements. Note 1 has been reworded to reference excessive layers found in <br />incoming Route Surveys. The highlighted sentence has been inserted to address excessive layers in surveys <br />received. <br />1. ALL INCOMING ROUTE SURVEYS THAT ARE REQUIRED FOR ENGINEERING DESIGN USE SHALL BE <br />RECEIVED ON A CD, AS AN ELECTRONIC COPY, AUTOCAD 2015 FORMAT, OR LATEST VERSION. <br />ELECTRONIC COPY OF ROUTE SURVEY SHALL NOT CONTAIN EXCESSIVE AUTOCAD LAYER STATES <br />OR LAYERS WITH INFORMATION THAT DOES NOT PERTAIN TO THE ROUTE SURVEY REQUESTED. <br />ALONG WITH AN ELECTRONIC VERSION, (3) THREE (24"x36") SIGNED AND SEALED COPIES OF <br />ROUTE SURVEYS SHALL BE SUBMITTED AND SHALL BE IN A MINIMUM SCALE OF 1"=40'. <br />ATTACHMENT A, Construction Standards, May 2019 <br />87 <br />