Laserfiche WebLink
INDIAN RIVER COUNTY COURTHOUSE PAGE 2 <br />METAL ROOFING REPLACEMENT PROJECT SECTION 074110 <br />JANUARY 15, 2021 STANDING SEAM METAL ROOF PANELS <br />1. Include construction details, material descriptions, dimensions of individual <br />components and profiles, and finishes for each type of panel and accessory. <br />B. Shop Drawings: <br />1. Include fabrication and installation layouts of metal panels; details of edge <br />conditions, joints, panel profiles, corners, anchorages, attachment system, trim, <br />flashings, closures, and accessories; and special details. <br />2. Accessories: Include details of the flashing, trim, and anchorage systems, at a <br />scale of not less than 1-1/2 inches per 12 inches (1:10). <br />C. Samples for Verification: For each type of exposed finish required, prepared on <br />Samples of size indicated below. <br />1. Metal Panels: 12 inches (305 mm) long by actual panel width. Include clips, <br />fasteners, closures, and other metal panel accessories. <br />1.5 INFORMATIONAL SUBMITTALS <br />A. Qualification Data: For Installer. <br />B. Product Test Reports: For each product, for tests performed by a qualified testing <br />agency. <br />C. Field quality -control reports. <br />D. Sample Warranties: For special warranties. <br />1.6 CLOSEOUT SUBMITTALS <br />A. Maintenance Data: For metal panels to include in maintenance manuals. <br />1.7 QUALITY ASSURANCE <br />A. Installer Qualifications: An entity that employs installers and supervisors who are <br />trained and approved by manufacturer. <br />B. UL -Certified, Portable Roll -Forming Equipment: UL -certified, portable roll -forming <br />equipment capable of producing metal panels warranted by manufacturer to be the <br />same as factory -formed products. Maintain UL certification of portable roll -forming <br />equipment for duration of work. <br />C. Mockups: Build mockups to verify selections made under Sample submittals and to <br />demonstrate aesthetic effects and set quality standards for fabrication and installation. <br />1. Build mockup of typical roof area and eave, including fascia, and soffit as shown <br />on Drawings; approximately 48 inches (1200 mm) square by full thickness, <br />including attachments, underlayment, and accessories. <br />