Laserfiche WebLink
H. Coordinate paragraph below with qualification requirements in Division I Section <br />"Quality Requirements" and as supplemented in "Quality Assurance" Article. <br />I. Qualification Data: For Installer. <br />J. Preconstruction Field Test Reports: Indicate which sealants and joint preparation <br />methods resulted in optimum adhesion to joint substrates based on preconstruction <br />testing specified in "Quality Assurance" Article. <br />K. Field Test Report Log: For each elastomeric sealant application. <br />L. Product Test Reports: Based on comprehensive testing of product formulations <br />performed by a qualified testing agency, indicating that sealants comply with <br />requirements. <br />M. Warranties: Special warranties specified in this Section. <br />1.5 QUALITY ASSURANCE <br />A. Installer Qualifications: Manufacturer's authorized Installer who is approved or <br />licensed for installation of clastomeric sealants required for this Project. <br />B. Source Limitations: Obtain each type of joint sealant through one source from a <br />single manufacturer. <br />C. Product Testing: Obtain test results for "Product Test Reports" Paragraph in <br />"Submittals" Article from a qualified testing agency based on testing current sealant <br />formulations within a 36 -month period preceding the Notice to Proceed with <br />commencement of the Work. <br />1. Testing Agency Qualifications: An independent testing agency qualified <br />according to ASTM C 1021 to conduct the testing indicated, as documented <br />according to ASTM E 548. <br />2. If retaining subparagraph below, also retain "Product Test Reports" Paragraph <br />in "Submittals" Article. <br />3. Test elastomeric joint sealants for compliance with requirements specified by <br />reference to ASTM C 920, and where applicable, to other standard test <br />methods. <br />4. Test elastomeric joint sealants according to SWRI's Sealant Validation <br />Program for compliance with requirements specified by reference to <br />ASTM C 920 for adhesion and cohesion under cyclic movement, adhesion -in - <br />peel, and indentation hardness. <br />5. Test other joint sealants for compliance with requirements indicated by <br />referencing standard specifications and test methods. <br />D. Pre -construction Field -Adhesion Testing: Before installing elastomeric sealants, <br />field test their adhesion to Project joint substrates as follows: <br />07900-3 <br />