1999-245 - Laserfiche WebLink

Home Browse Search

• Emergencies: 6.27 In emergencies affecting the safety or protection of persons or the Work or property at the site or adjacent thereto, CONTRACTOR, without special instruction or authorization €rom ENGINEER or OWNER, is obligated to act to prevent threatened damage, injury or toss CONTRACTOR shall give ENGINEER prompt written notice that any significant changes in the Work or variations from the Contract Documents have been caused thereby. If ENGINEER determines that a change in the Contract Documents is required because of the action taken in response to an emergency, a Work Directive Change or Change Order will be issued to document the consequences of the changes or variations. Shap Drawings and Samples:. 6.26 After checking and verifying all field measurements and after complying with applicable procedures specified in the General Requirements, CONTRACTOR shall submit to ENGINEER for rek%iew in accordance with the accepted schedule of Shop Drawing submissions (see paragraph 2.9), or for other appropriate action if so indicated in the Supplementary Conditions, five (6) copies (unless otherwise specified in the General Requirements) of all Shop Drawings, which will bear a stamp or specific written indication that CONTRACTOR has satisfied CONT'RACTOR's responsibilities under the Contract Documents with respect to the review of the submission. All submissions will be identified as ENGINEER may require. The data shown on the Shop Drawings will be complete with r ", Ct to quantities, dimensions, speed performance and design criteria, materials and similar data to enable ENGINEER to review the information as required. 6.29 CONTRACTOR shall also submit to ENGINEER for review with such promptness as to muse no delay in Work, all samples requirod by the Contract Documents. All samples will have been chocked by and accompanied by a specific written indication that CONTRACTOR has satisfied CONTRACTOR's responsibilities under the Contract Documents with respect to the review of the submission and will be identified clearly as to material, Supplier, pei 4inent data such as catalog numbers and the use for which intended. 6.30 Before submission of each Shop Drawing or sample CONTRACTOR shall have determined and verified all quantities, dimensions, specified performance criteria, installation requirements, materials, catalog numbers and similar data with respect thereto and reviewed or coordinated each Shop Drawing or sample with other Shop Drawings and samples and with the requirements of the Work and the Contract Documents. 6.31 At the time of each submission, CONTRACTOR shall give ENGINEER specific written notice of each variation that the Shop Drawings or samples may have from the requirements of the Contract Documents, and in addition, shall cause a specific notation iu be maeie on each Snop urawing stinmittod to EM31NFER for review of each such variation. 6.32 ENGINEER will review with reasonable promptness Shop drawings and samples, but ENGINEER's review will be only for conformance with the design concept of the Project and for compliance with the information given in the Contract Documents and shall not extend to means, methods, techniques, sequences or procedures of construction (except where a specific means, methods, technique, sequence or procedure of construction is indicated in or required by the Contract Documents) or to safety precautions or programs incident thereto. The review of a separate item as such will not indicate review of the assembly in which the item functions. CONTRACTOR shall snake corrections required by ENGINEER, and shall return the required number of corrected copies of Shop Drawings GENERAL CONDI'T'IONS � GC - 18