Laserfiche WebLink
11 <br />Andersen- <br />8001' WINDOWS <br />r lection 07812 <br />f ^ 5. Transom Flashing: Place flashing between adjacent roof window units. Install transom flashing under frame gasket at roof <br />window frame member. Transom flashing shall become an integral part of the flashing system, <br />e <br />a. Pre -farmed and welded aluminum (.031 inch). <br />6. Auxiliary Water Deflector: iUse auxiliary water deflector where roof pitch Is 20112 to 68/12. <br />a. Pre-formod aluminum (0.024 inctn). <br />06 ACCESSORIES <br />A. Insect Screens: Provide venting roof windows with an insect screen, including attachment hardware.. <br />1. Frames: 0.024` rolled aluminum frame with chromate conversion coaling and color thermoset finish. Color-. Terralone. <br />2, Insect Screen Cloth: 18 x 16 aluminum mesh, gun metal finish. <br />B. Interior Pleated Shades: Fit roof window openings wilh pleated shades where indicated on Drawings. Provide shades capable <br />of being drawn up out of viewing area by using the standard handle or opilanal extension pole. <br />1. Color: Antique While, [Translucent] 10paque) fabric. <br />C. Remote Roof Window Opener: Provide electric roof window opener for remote operation of venting unit where indicated on <br />Drawings, Electric opener system to consist o1 a 16-voll power operator, power supply (converiing 120 -volt AC to 16 -volt DC), <br />push bullon command center, rain sensor, which will algnal the power operator to close the unit, and all necessary mounting <br />hardware. Provide safely connector which will not permit operation of the electric roof window opener unless Insect screen Is <br />in place. <br />D. Extension Pales: Provide one (1) telescoping W to 10' corrosion resistant, extension pole with vinyl coated handle for operaling <br />vent Operator and pleated shades. Where extension pole use is required, replace operator handle with hex socket adapter, and <br />replace shade handle with pole adapter, <br />? 07 FABRICATION <br />A. Preservative Treatment: Treat wood sash and frame members alter machining with a water repellent preservative In <br />accordance with NWWDA I.S. 4. <br />B. 'Sash Members: Cover exterior surfaces of sash with aluminum structural sash cover. <br />C. Glazing: Factory glaze using elaslorneric gaskets and a full bad of high performance silicone glazing sealant at the perimeter. <br />D. Factory apply weatherstripping. <br />PART 3 EXECUTION <br />11 INSPECTION <br />A. Inspect opening before installation is commenced. <br />i. Verify rough opening is square and dimensions are correct - <br />2. Verify wood framinq is dry, clean, sound rind well nailed, and/or glued. free of vnirrs and wAhmit nnRRIn nt ini-4- <br />Ensure Ilial nail heads are driven flush will) all surfaces In opening arid within 3" of rough opening. <br />3.112 PREPA'RATiON <br />A. Open carton and remove roof window and all Paris. Inspect roof window, Verify Thai roof window Is not damaged and a,t parts <br />are included before disposing of carton. <br />M Leave handle on operating sash in closet/ position. <br />07512-0 <br />