1999-177B - Laserfiche WebLink

Home Browse Search

CJ F. Coordination: 1. Provide finish coats which are compatible with prime paints used. Provide barrier coats over incompatible primers w:iere required. Notify Architect in writing of anticipated problems using specified coatings with substrates primed by others. F. Surface Preparation: 1. Perform preparation and cleaning procedures in strict accordance with coating manufacturer's instructions of each substrate condition. 2. Remove hardware and accessories, machined surfaces, plates, lighting fixtures and similar items in place and not to be finish -painted or provide surface -applied protection. Re- install removed items and remove protective coverings at completion of work. 3. Seal wood required to be job -painted. Prime edges, ends, face, undersides and backsides of counters, cases, cabi- nets, counters, etc. Use varnish for back -priming where transparent finish is required. 4. Backprime interior paneling only where masonry, plaster, or other wet wall construction occurs on backside. 5. Seal tops, bottoms, and cut-outs of wood doors with heavy coat of varnish or similar sealer immediately upon delivery to job. G. Material Preparation: I. Mix, prepare, and store painting and finishing materials in accordance with manufacturer's directions. H. Application: 1. Apply painting and finishing materials in accordance with manufacturer's directions. Use applicators, and techniques best suited for materials and surfaces to which applied, but in no case will spray application be used unless approved by Architect. 7 Anpltr arlr�i;t; a1 coato •hon ;dcr s, tain&, 04 QLher cond1 ig!n show through final paint coat, until paint film is of uniform finish, color and appearance. 3. Paint _surfaces behind movable eauinment same as similar ex- posed surfaces. Paint surfaces behind permanently fixed equipment with prime coat only before equipment is in- stalled. 4. Finish xte 'or doors on topes, bottoms and edges same as exterior faces, unless otherwise indicated. 49900-2