1999-338A - Laserfiche WebLink

Home Browse Search

i 0 raccordance with the Contract Documents. CONTRACTOR shall be solely responsible for rte means, methods, techniques, sequences and procedures of construction, but CONTRACTOR shall not be responsible for the negligence of others in die design or selection of specific means, methods, tec]miques, sequences or procedures of Construction which is indicated in and required by the Contract Documents. CONTRACTOR shall be responsible to see that the finished Work complies accurately with rte Contract Documents. 6.2 CONTRACTOR shall keep on die Work at all times during its progress a competent resident superintendent, who shall not be replaced without written notice to OWNER and ENGINEER except ' under extraordinary circumstances. The superintendent will be CONTRACTOR's representative at tie site and shall have audiorityto act on behalf of CONTRACTOR. All communications given to the supermterident shall be as binding as ifgiven to CONTRACTOR - I I Labor, Mihterials and Equipment! 6.3 CONTRACTOR shall provide competent, suitable qualified personnel to survey and lay out tie Work. and per%mi construction as required by the Contract Documents. CONTRACTOR shall at all times maintain good discipline and order at the site. Except in connection with the safety or protection of persons or the Work or property at tie site or adjacent thereto, and except as otherwise indicted in fine Contract Documents, all Work at tie site shall be performed during regular working hours, and CONTRACTOR will not permit overtime work or tine performance of Work on Saturday, Sunday or any legal holiday without OWN ER's written consent given after prior written notice to ENGINEER. 6.4 Unless otherwise specified in the General Requirements, CONTRACTOR shall furnish and assume full responsibility for all material, equipment, labor, transportation, construction equipment and machinery, tools, appliances, fuel power, light, heat, telephone, water sanitary facilities, temporary facilities and all other facilities and incidcrtals necessary for the fur ishnig, perfornhance, testing, start- up and completion of the Work. 6.5 All materials and equipment shall be of good quality and new, except as otherwise provided in the Contract Documents- If required by ENGINEER, CONTRACTOR shall furnish satisfactory evidence (including reports of required tests) as to the kind and quality of materials aiid equipment, All nhaterial and equipment shall be applied, installed, connected, erected, used, cleaned and conditioned in accordance with dash instructions of the applicable Supplier except as otherwise provided in tie Contract Documents; but no provision of any such instructions will be efTwive to assign to ENGINEER, or any of ENGINEER's consultants, agents or employees, any duty or authority to supervise or direct die furnishing or performance of tie Work or any duty or authority to undertake responsibility contrary to the provisions of paragraph 9.15 or 9.16. Adjusting Progress Schedule; 6.6 CON'T'RACTOR shall submit to ENGINEER for acceptance (to die extent indicated in paragraph 2.9) adjustments in the progress schedule to reflect the impact thereon of new developments; these will conform generally to the progress then if effect and additionally will comply with any provisions of the General Requirements applicable thereto- Substitutes or "Or -Equal" Rents: 6.7.1. Whenever materials or equipment are specified or described in tie Contract Documents by using the name of proprietary item or the name of a particular supplier, tie naming of the item is intended to establish the type, hi ction and quality required and to establish a basis for bidding- Unless the name is followed by words indicating that no substitution is permitted, substitute inateriAs or equipment may be reviewed by Engineer if sufficient information is supplied by CONTRACTOR to allow Engineer GENERAL CONDITIONS GC - 11