2024-017A - Laserfiche WebLink

Home Browse Search

Mr. Himanshu H. Mehta, P.E. 20 December 2023 Page 9 210.370(3), F.A.C. As part of this task, Geosyntec will perform calculations to estimate the annual emission rates of non -methane organic compounds (NMOCs) and VOCs from the LFG to determine if the facility designation has changed from voluntary to mandatory with regard to operation and reporting requirements of the active GCCS under the New Source Performance Standards (NSPS) requirements. The results of the annual LFG sulfur content test will be used in the EAOR calculations. In the event of a status change, Geosyntec will advise the SWDD of its implications. • Semi -Annual Monitoring Report: Geosyntec will prepare and submit two semi-annual monitoring reports to demonstrate compliance with the federal requirements of the Title V permit. The reports will address the following permit conditions or compliance requirements: o Submittal of reports of any required monitoring at least every 6 months. All instances of deviations from permit requirements must be clearly identified in such reports. o Reporting, in accordance with requirements of subsection 62-210.700(6) and Rule 62- 4.130, F.A.C., of deviations from permit requirements, including those attributable to upset conditions defined in the permit. Reports shall include the probable cause of such deviations, and any corrective actions or preventative measures taken. o Reports shall be accompanied by a responsible official, pursuant to subsection 62- 213.420(4), F.A.C. The reports will only address deviations from the Title V permit conditions. Landfill and LFG operation and maintenance (O&M) data are not required to be reviewed and submitted to the FDEP per the Title V permit. • Annual Title V Emissions Fee: The EAOR application used for reporting to the FDEP will automatically calculate the annual emission fee for the facility. Geosyntec will notify the SWDD of the fee amount and will submit the check for payment of the fee on behalf of the SWDD prior to the April 1 deadline. • Annual LFG Sulfur Content Test: Geosyntec will collect three samples of LFG annually to determine the sulfur content in accordance with ASTM Method D5504-12 or D7493. The samples will be tested by a certified air testing laboratory. The laboratory test results will be used to calculate sulfur emissions and a report prepared for submittal to the FDEP. The LFG sulfur content testing will be completed no later than 31 December 2024, and the corresponding reporting will be completed no later than 45 days after testing. NCP2323548/JL23073 2024 Compliance Monitoring Proposal engineers I scientists I innovators