2024-251 - Laserfiche WebLink

Home Browse Search

Environmental Consulting & Contracting September 3, 2024 Himanshu Mehta Managing Director Indian River County - Solid Waste Disposal District 1325 74th Avenue SW Vero Beach, FL 32968 Subject: Proposal to Install Leachate Evaporator Fiber Optics Cable and Control Panel Indian River County Landfill, Vero Beach, Florida Dear Mr. Mehta: SCS Field Services (SCS -FS) is pleased to provide this proposal to the Solid Waste Disposal District (SWDD) for the subject work. SCS -FS is prepared to order materials and schedule work upon receipt of your approval. A summary of the list of materials, assumptions, and cost is outlined below based on design drawings, parts list, and specifications provided by Kimley Horn. SCOPE OF WORK SCS -FS and our sub -contractor, Complete Electric, Inc. (CEI), will provide labor, equipment and electrical materials for the installation of the leachate evaporator electrical panel and fiber optics cable that runs from the new panel to the new flare station. CEI will perform the following tasks: • Construct a support rack for the new Leachate Control panel where shown. Utilize 4" aluminum vertical conduit, with stainless steel horizontal struts, and stainless steel fasteners/hardware. • Supply and install a UL listed Leachate Control cabinet designed to meet the specifications on sheets E -410A. and E-410 dated July of 2023. This will be a customer built to order control cabinet for this application. It will include a N4X enclosure with Vents/Fans and Heat exchanger along with the 480V, 20HP three phase VFD. • Install conduit from the existing 480V electrical panel, to new Leachate panel. • Install conduits from Leachate control panel, to Leachate tank pump/motor. • Install a 3 pole 480V rated Square D EDB breaker in the existing 480V panel to supply the Leachate project. Label panel upon completion to reflect these changes. • Pull in 480V rated CU feeders from existing panel, to Leachate control panel, as well as 480V feeders to the pump/motor at base of tank. • Expose the existing in ground pull boxes that were installed for the Fiber cable. **If we are not able to locate these boxes, additional fees will be required to address this issue. • Provide and install (1) 12 strand (6 pair) tight buffer indoor/outdoor single mode fiber optic cable from the Leachate project, to the new High Pressure Blower skid project. Utilize all existing underground pull boxes, and conduits that were installed for this application. • Terminate both ends of the fiber cable in a fiber enclosure with LC connectors as requested. • Leave slack in cable at each end, as well as each pull box. 1800 Pembrook Dr., Suite 300, Orlando, Florida 32810