2004-105 - Laserfiche WebLink

Home Browse Search

(conducted by the registered professional engineer, or other appropriate individual as authorized by law , or under his or her direct supervision ) or review of as-built drawings ' for the purpose of determining if the work was completed in compliance with approved plans and specifications. As-built drawings shall be the permitted drawings revised to ' reflect any changes made during construction . Both the original and any revised specifications must be clearly shown . The plans must be clearly labeled as " as-built" or " record " drawing . All surveyed dimensions and elevations shall be certified by a ' registered surveyor. The following information , at a minimum , shall be verified on the as-built drawings : ' 1 . Dimensions and elevations of all discharge structures including all weirs , slots , gates , pumps , pipes , and oil and grease skimmers ; 2 . Locations , dimensions , and elevations of all filter, exfiltration , or underdrain systems including cleanouts , pipes , connections to control structures , and points of discharge to the receiving waters ; 3 . Dimensions , elevations , contours , or cross-sections of all treatment storage areas sufficient to determine state-storage relationships of the storage area and the permanent pool depth and volume below the control elevation for normally wet systems , when appropriate ; ' 4 . Dimensions , elevations , contours , final grades , or cross-sections of the system to determine flow directions and conveyance of runoff to the treatment system ; 5 . Dimensions , elevations , contours , final grades , or cross-sections of all conveyance systems utilized to convey off-site runoff around the system ; 6 . Existing water elevation (s) and the date determined ; and Elevation and location of benchmark(s) for the survey. ' 11 . The operation phase of this permit shall not become effective until the permittee has complied with the requirements of general condition 9 above , the District determines the ' system to be in compliance with the permitted plans , and the entity approved by the District in accordance with subsections 7 . 1 . 1 through 7 . 1 . 4 of the Applicant' s Handbook : Management and Storage of Surface Waters , accepts responsibility for operation and ' maintenance of the system . The permit may not be transferred to such an approved operation and maintenance entity until the operation phase of the permit becomes ' effective . Following inspection and approval of the permitted system by the District, the permittee shall request transfer of the permit to the responsible approved operation