Laserfiche WebLink
SECTION 01215 <br /> ' GENERAL QUALITY CONTROL <br /> ' 1 . 1 DESCRIPTION OF REQUIREMENTS <br /> ' A . Definitions : Specific quality control requirements for the work are indicated <br /> throughout the Contract Documents . The requirements of this section are primarily <br /> related to the performance of the work beyond the furnishing of manufactured <br /> ' products . The term "Quality Control" includes , but is not necessarily limited to , <br /> inspection and testing and associated requirements . This section does not specify <br /> or modify the OWNER and ENGINEER duties relating to quality review and <br /> ' Contract surveillance . <br /> 1 . 2 RESPONSIBILITY FOR INSPECTIONS AND TESTS <br /> ' A . OWNER Responsibility: The OWNER will employ and pay for the services of <br /> independent testing laboratories to perform required inspections and tests . See <br /> Section 01410 . <br /> Be CONTRACTOR's General Responsibility: No failure of test agencies , whether <br /> ' engaged by the OWNER or CONTRACTOR, to perform adequate inspections of <br /> tests or to properly analyze or report results , shall relieve the CONTRACTOR of <br /> responsibility for the fulfillment of the requirements of the Contract Documents . Itis <br /> ' recognized that the required inspection and testing program is intended to assist the <br /> CONTRACTOR , OWNER , ENGINEER , and governing authorities in the nominal <br /> determination of probable compliance with requirements for certain crucial elements <br /> ' of work. The program is not intended to limit the CONTRACTOR in his regular <br /> quality control program , as needed for general assurance of compliance . <br /> ' 1 . 3 QUALITY ASSURANCE <br /> A . General Workmanship Standards : It is a requirement that each category of <br /> ' tradesman or installer performing the work be pre-qualified , to the extent of being <br /> familiar with the applicable and recognized quality standards for his category of <br /> work, and being capable of workmanship complying with those standards . <br /> 1 .4 SUBMITTALS <br /> ' A. General : Refer to Section 01330 for the general submittal requirements applicable <br /> to inspection and test reports , project photographs , damage surveys , quality control <br /> samples , maintenance agreements , guarantees , warranties , and similar <br /> ' documentation of quality compliance as required . <br /> Last revised 5/29/02 01215= 1 EAST GIFFORD <br />