2008-276 D - Laserfiche WebLink

Home Browse Search

1.04 CODES, INSPECTION AND FEES A. All material and installation shall be in accordance with the latest edition of the National Electrical Code and all applicable national, local and state codes. B. All equipment and material shall be U.L. listed. C. Pay all fees required for permits and inspections. 1.05 TEMPORARY ELECTRICAL FACILITIES A. The Contractor shall furnish, install, and maintain all materials and equipment required to provide temporary light and power to perform the work of all trades during construction until work is competed. Adequate lighting and receptacle outlets for operation of hand tools shall be provided throughout the project, including trailers, field offices, etc. and shall be extended as construction progresses. B. All reasonable safety requirements shall be observed to protect workers and the public from shock and fire hazards. 1. Ground fault circuit interrupters shall be employed in accordance with codes. 2. Ground wires are required in all circuits. Ground poles are required on all outlets. All metallic cases shall be grounded. 2. Raintight cabinets shall be used for all equipment in wet locations. 1.06 INTERPRETATION OF DRAWINGS A. The Drawings are not intended to show exact locations of conduit runs. B. All three-phase circuits shall be run in separate conduits unless otherwise shown on the Drawings. C. Unless otherwise approved by the Engineer conduit shown exposed shall be installed exposed; conduit shown concealed shall be installed concealed. D. Where circuits are shown as "home -runs" all necessary fittings and boxes shall be provided for a complete raceway installation. E. All wire, conduit, circuit breaker, and motor starter sizes shown on the drawings are indicative of the sizes required based upon the equipment shown. These may vary depending upon the actual equipment furnished. The Contractor shall make adjustments as required to meet the installation requirements of equipment. 044572017 16050-2