2007-263B - Laserfiche WebLink

Home Browse Search

Indian River County Administration Complex Bldg. 1 - 2°d Floor - West - Punch List Tuesday - 07/ 17/07 & Thursday -07/19/07 July 26, 2007 Page 24 Restroom 710 (continued) 5. Hollow metal frame left side below the strike plate scratched needs to be touched-up with paint. 6. Floor drain needs to be cleaned of tape. 7. Wall finish to the right of the paper towel holder has white paint on it needs to be repaired. 8 . Ceramic file floor and base needs to be cleaned of drywall dust and paint. 9. Grout joints around the flush valve escutcheon plate unacceptable, different colors than the regular joint. Also, ceramic tile opening cut too large at the escutcheon for the flush valve. Needs to be repaired or replaced. 10. Ceramic tile underneath the lavatory finish is damaged in two locations. 11 . Top edge of hollow metal door frame 710 painters tape needs to be removed and finish needs to be repaired. 12 . Left outside comer at shower ceramic tile edges not acceptable, should be a bull nose finish. 13. Height of shower unit where the drywall abuts the shower head very rough, irregular, drywall mud, voids in the finish. Needs to be corrected. 14. Drain cover for shower unit needs to be properly installed, its loose and tape needs to be removed from the shower unit. 15 . Top right side of shower unit, holes in the fiberglass flange for the shower unit needs to be filled in, screw heads need to be covered up, they are exposed. 16. Drywall opening at the shower inside corner where they abut the ceramic tile painters tape left in place and painted over, needs to he removed and corrected. Also, the same for the fire alarm horn strobe. 17 . Ceramic tile floor needs to be cleaned around the water closet. 18 . Trim piece at the drywall opening the 2x6 block front piece at the drywall opening cut rough and irregular, not acceptable. Clerk To The Board - Reception 801 1 . Two light fixtures not working in this office at this time. 2. Outside face of Door 801 metal frame for view light top and bottom edges chipped. 3 . Left inside corner to the left of Door 801 corners needs to be sanded and repainted. 4. Drywall above the door and side light of door 701 finish needs to be repainted where it has been patched and repaired. 5 . Drywall to the right of recessed can lights damaged needs to be patched and repaired . 6. Bottom right of hollow metal frame for side light drywall needs to be sanded and repainted, very rough and irregular and also the drywall below the fill of the side light needs to be sanded and repainted and where it abuts the window sill needs to be caulked, sanded and repainted. 7. Drywall to the right of the hollow metal door frame between the window sill and the vinyl base needs to be sanded, caulked and repainted. & Vinyl base to the right of door 801 , cut too short. 9 . Plastic laminate base cabinet for Reception counter joint, plastic laminate was cut on the left side with the small piece approximately 12 inches wide, ethically not acceptable . 10. Counter top needs to be cleaned of paint. 11 . Drywall to the right of the counter top above the back splash needs to be patched and repaired and also at the outside corner. 12. Area where the stand-up counter no lights in this area, very hard to see, can not punch out at this time. 13 . Fire alarm horn strobe needs to be held tight to the drywall. 14. Ceiling tiles over the stand-up area, one on either side of the sprinkler head location, one tile stained and other is damaged. 15. Drywall header over the reception counter bottom front edge of drywall is very rough, irregular, needs to be sanded and paint cut in nice and neat. D O N A D I O & Associates, Architects, P.A.