2007-263E - Laserfiche WebLink

Home Browse Search

Indian River County Administration Complex Bldg. 2 - 1st Floor Punch List - Friday - 06/29/07 July 09, 2007 Page 7 Work Room 207 1 . Hollow metal door frame 207 bottom left is dented. 2. Left side of Door 207 between the bottom hinge and the middle hinge edges are chipped. 3 . Inside face of Door 207 needs to be cleaned of dirt and debris. 4. Right of door 207 vinyl base needs to be cleaned of paint and drywall mud. 5. General areas throughout this room of the vinyl base needs to be cleaned of drywall mud, dirt, debris and paint. 6. Drywall around electrical outlet between the metal borrowed light 205 and borrowed light 204 needs to be patched and repaired . 7. Inside face of hollow metal door frame 204 BLl needs to be repainted on the bottom left edge. 8. West wall data outlet D04 drywall opening cut too large needs to be patched and repaired. 9. East wall electrical outlet cover plates not installed. 10. Electrical outlet to the right of north exterior wall and window drywall needs to be sanded and repainted. 11 . Six ceiling tiles not in place at this time/ 12 . Northeast inside corner ceiling tile has paint on it. 13 . Outside corner coming off of Door 207A is chipped and needs to be repainted in numerous areas. 14. Drywall on the outside of Door 207 top left corner needs to be repainted and the drywall where it abuts the header of the metal frame, door frame needs to be sanded and repainted. 15. Drywall around fire alarm horn strobe to the left of Door 207 opening cut tool large needs to be patched and repaired. Also, in this same area carpet glue on the walls. 16. Right of Door 207A outside corner vinyl base is not adhering. 17. Open alcove to the right of Work Room 207 furniture is installed completely in this area. Walls need to be touched-up with paint in numerous locations. 18. Back wall drywall needs to be patched and repaired around electrical outlet and electrical outlet cover needs to be set flush to the drywall. This is the Office Alcove between Work Room 207 and Office 210. 19. Above this area alcove two ceiling tiles missing not in place. 20. Left outside corner to the left of Door 210A fingerprints on the drywall needs to be repainted . Office 210 1 . Door 210A - Bottom left of hollow metal door frame 210A is damaged. 2. To of hollow metal door frame where drywall abuts it needs to b sanded, caulked and repainted. 3 . Hollow metal door frame needs to be repainted from the floor up approximately 18 to 24 inches . 4. Inside face of Door 210 below the view light finish has been damaged, irregular. 5 . West wall above the vinyl base carpet glue on the wall . 6. Exterior window on the west wall right side drywall jamb needs to be repainted. 7 . North wall electrical outlet to the far right drywall around the outlet is irregular needs to be sanded and repainted. 8. Boxed out column drywall surface above the vinyl base needs to be repainted. Also, the outside corners where the vinyl base is not adhered to this outside column area. 9. Electrical outlet to the left f Door 210 the outlet device needs to be cleaned of paint and the outlet needs to be set plumb and level. 10. Two ceiling tiles not in place. 11 . Ceiling grid around the boxed out column is not setting flush to the drywall . Also, ceiling grid between the boxed out column and the north wall has paint on it, that is the grid along the wall. 12. Drywall to the right of Door 210 and to the Vestibule on Corridor 208 side needs to be patched and repaired above the vinyl base, drywall is damaged and also glue on the wall. D O N A D I O & Associates, Architects, P.A.