2008-213 (8) - Laserfiche WebLink

Home Browse Search

L After the prime coat has had adequate time to cure, and prior to the installation of a temporary surface course, the Contractor shall clean the prepared base of all loose sand and other deleterious materials . If, in the opinion of the Engineer, the prepared surface is unsuitable to receive the temporary surface course without tacking, a tack coat. Once the surface has been properly prepared, the Contractor shall install a 2- inch layer of Type II Asphaltic Concrete in accordance with the details shown on the Plans as a temporary surface course . Said Type II Asphaltic Concrete shall conform to all of the applicable requirements of Section 332 of the Florida Department of Transportation " Standard Specifications for Road and Bridge Construction, " 2000 except that "Job Mix Formula" will not be required. The temporary surface course may be spread with a spreader box in lieu of a self-propelled mechanical spreader. B . State-Owned Public Pavement 1 ) Restoration within all State-owned and maintained paved rights-of-way shall be made in strict compliance with these specifications and the details shown on the Plans . All construction materials and procedures shall conform to the Florida Department of Transportation " Standard Specifications for Road and Bridge Construction, " 2006 Edition. 2) All work shall be subject to final inspection and approval of the Florida Department of Transportation and shall be completed as expeditiously as possible . C . Driveways, Parking Lots and Miscellaneous Thoroughfares 1 ) All driveways , parking lots, unpaved streets, and other miscellaneous thoroughfares disturbed by trenching operations shall receive a minimum 6-inch thickness of base course as previously specified in paragraph 3 .A. 1 ) above . Those areas with surface finishes (asphalt, rock, concrete, etc . ) disturbed by trenching operations shall have the final surface courses replaced in kind with a minimum 14nch thickness surface course , except for concrete which shall be a minimum thickness of 4-inches . The Contractor's attention is called to the fact that all surface improvements constructed since the date of base mapping may not be shown and that the Contractor is required to repair all surfaces disturbed by construction, whether shown on the plans or not. D . Rights- of-Way and/or Easements in Grass and Shrubbery Plots 1 ) Rights-of--way and/or easements in grass and shrubbery plots shall be restored to the condition existing prior to making the excavation . All shrubbery, ornamental trees and other plantings shall be fully protected. If it is found necessary to remove any grass, shrubbery or 02900 — Off-Site Surface Restoration 02900 - 3