2006-130 - Laserfiche WebLink

Home Browse Search

SCOPE OF SERVICES We respectfully submit the following Scope of Services and Fee Schedule for your review: Task 1 — Meetings / Coordination CEI will attend all meetings critical to the performance and completion of the project. CEI will coordinate with land owners, railroad and other agencies for access to properties Task 2 — Preliminary Survey Baseline CEI will research local published records along with documentation provided by the COUNTY, this information will be used along with limited field measurements to compute a preliminary baseline for the length of the primary corridor to be used for cross sections. The preliminary baseline alignment plot will be supplied to the COUNTY for review. Task 3 — Primary Control • Primary Horizontal Control — CEI will establish a Horizontal Control Network, consisting of Ten ( 10) poured concrete monuments, along the corridor using Static GPS methods. The network shall meet or exceed the accuracy requirements for "Suburban " with the minimum relative distance accuracy for this type of horizontal control to be 1 foot in 7500 feet ( 1 : 7500) as classified in the "Minimum Technical Standards" for Surveying and Mapping in the State of Florida as set forth by the Florida Board of Professional Surveyors and Mappers in Chapter 61G17-6, Florida Administrative Code Pursuant to Section 472.027 Florida Statutes. CEI Crews will reconnoiter published horizontal control surrounding the project corridor. New stations will be set in inter-visible pairs outside of the corridor where there is satellite visibility, and shall be referenced to the final corridor alignment. • Primary Vertical Control - CEI will establish a Vertical Control Network along the corridor using 3 - wire differential leveling technique relative to the NGVD29 elevations for the benchmarks provided by the COUNTY. The network will meet or exceed the accuracy requirements for vertical control based on the "Minimum Technical Standards" for surveying and mapping in the State of Florida as set forth by the Florida Board of Professional Surveyors and Mappers in Chapter 61G17-6, Florida Administrative Code, pursuant to Section 472-027, Florida Statutes. • New vertical control stations will be set approximately every 1500 ' and shall be referenced to the final corridor alignment. • Primary control shall provide the horizontal (NAD 83/99) and vertical control (NGVD 29) values. Task 4 — Secondary Control Secondary Horizontal and Vertical Control — CEI will establish secondary traverse control along the corridor using RTK GPS and conventional survey methods. The secondary control will be used to support cross-sections and topographic mapping efforts, and shall be referenced to the final corridor alignment. Task 5 — Cross Sections / Supplemental Planimetrics Cross sections every 100 ' will be located on each side of the preliminary survey baseline along the primary corridor and along the existing road north near the proposed concrete plant. Cross sections shall vary in length; being a +/- 300 ' corridor (estimated 150 ' +/- from baseline) in "un-improved" areas and +/- 25 ' over existing property/subdivision lines (or as needed) into "improved" lots or lands in an effort to supply adequate data to determine flow patterns. All home and/or structure (i.e . detached sheds/garages) finish floor elevations (low floor) shall be obtained (see attached sketch) . CEI will supplement aerial planimetric data within corridor for obscured areas. CEI will locate above ground utilities within the corridor. >F:\Engineering\Capital Projects\0390-Annual Survey Contracts\Creech\2006\Fleming Ext. 06\0309 Fleming Ext. Creech IRC WO#4 -04-18-06- mob.doc