2012-186 - Laserfiche WebLink

Home Browse Search

NOTICE OF INTENT TO USE THE GENERAL PERMIT FOR CONSTRUCTION OF WATER MAIN EXTENSIONS FOR PWSs Proiect me : 92nd Court Waterline Extension T Permittee : N/A g. The inside diameter of new or altered water mains that are included in this project and that are being designed to provide fire protection and serve fire hydrants will be at least six inches. [FAC 62-555 .320(21 )(b) and RSWW 8. 1 . 2] Isis New or altered water mains that are included in this project and that are not being designed to carry fire flows do not have fire hydrants connected to them . [FAC 62-555. 320(21 )(b) and RSWW 8. 1 . 5] i . This project is being designed to minimize dead-end water mains by making appropriate tie-ins where practical . [FAC 62-555 . 320(21 )(b) and RSWW 8. 1 .6.a] j . New or altered dead-end water mains included in this project will be provided with a fire or flushing hydrant or blow-off for flushing purposes. [FAC 62 -555 . 320(21 )(b) and RSWW 8. 1 . 6. b] !t v/ k. Sufficient valves will be provided on new or altered water mains included in this project so that inconvenience and sanitary hazards will be minimized during repairs. [FAC 62-555 .320(21 )(b) and RSWW 8. 2] _ I . New or altered fire hydrant leads included in this project will have an inside diameter of at least six inches and will include an auxiliary valve. [ FAC 62-555 .320(21 )(b) and RSWW 8 .3 .3] m . All fire hydrants that will be installed under this project and that will have unplugged, underground drains will be located at least three feet from any existing or proposed storm sewer, stormwater force main , pipeline conveying reclaimed water regulated under Part III of Chapter 62-610 , F . A. C., or vacuum-type sanitary sewer; at least six feet from any existing or proposed gravity- or pressure-type sanitary sewer, wastewater force main , or pipeline conveying reclaimed water not regulated under Part III of Chapter 62- 10, F.A .C. ; and at least ten feet from any existing or proposed "on-site sewage treatment and disposal system . " [FAC 62-555 . 314(4)] Xn . At high points where air can accumulate in new or altered water mains included in this project, provisions will be made to remove the air by means of air relief valves, and automatic air relief valves will not be used in situations where flooding of the valve manhole or chamber may occur. [FAC 62-555 . 320(21 )(b) and RSWW 8 .4 . 1 ] o. The open end of the air relief pipe from all automatic air relief valves installed under this project will be extended to at least one foot above grade and will be provided with a screened, downward-facing elbow. [FAC 62-555 .320(21 )( b) and RSWW 8 .4 .2] p . New or altered chambers, pits, or manholes that contain valves, blow-offs, meters, or other such water distribution system appurtenances and that are included in this project will not be connected directly to any sanitary or storm sewer, and blow-offs or air relief valves installed under this project will not be connected directly to any sanitary or storm sewer. [FAC 62-555 . 320(21 )(b) and RSWW 8.4.3] q . New or altered water mains included in this project will be installed in accordance with applicable AWWA standards or in accordance with manufacturers' recommended procedures. [FAC 62-555 .320(21 )(b), RSWW 8. 5 . ► , and " 1� AWWA standards as incorporated into FAC 62-555.330] )7 7 r. A continuous and uniform bedding will be provided in trenches for underground pipe installed under this project; backfill material will be tamped in layers around underground pipe installed under this project and to a sufficient height above the pipe to adequately support and protect the pipe ; and unsuitably sized stones (as described in applicable AWWA standards or manufacturers' recommended installation procedures) found in trenches will be removed for a depth of at least six inches below the bottom of underground pipe installed under this project. [FAC 62-555 .320(21 )(b), RSWW 8.5 .2] s . All water main tees, bends, plugs, and hydrants installed under this project will be provided with thrust blocks or restrained joints to prevent movement. [FAC 62-555 .320(21 )(b) and RSWW 8 .5.4] t. New or altered water mains that are included in this project and that will be constructed of asbestos-cement or polyvinyl chloride pipe will be pressure and leakage tested in accordance with AWWA Standard C603 or C605, respectively, as incorporated into Rule 62-555 .330, F .A.C ., and all other new or altered water mains included in this project will be pressure and leakage tested in accordance with AWWA Standard C600 as incorporated into Rule 62-555 .330 . [FAC 62-555 .320(21 )(b) 1 and AWWA standards as incorporated into FAC 62-555 . 330] u . New or altered water mains, including fire hydrant leads and including service lines that will be under the control of a public water system and that have an inside diameter of three inches or greater, will be disinfected and bacteriologically evaluated in accordance with Rule 62-555 .340, F .A. C . [FAC 62-555 .320(21 )(b)2 and FAC 62- 555 .340) v. New or altered water mains that are included in this project and that will be installed in areas where there are known aggressive soil conditions will be protected through use of corrosion-resistant water main materials, through encasement of the water mains in polyethylene, or through provision of cathodic protection . [FAC 62- 555 .320(21 )(b) and RSWW 8. 5 . 7.d] DEP Form 62-555.900(7)A1temato Page 4 Effective August 28, 2003