2/21/1968 - Laserfiche WebLink

Home Browse Search

the same raceway,: except in load gutter in meter room. (p) In the wiring of cold -storage plants and rooms or buildings of similar character, all wires used for light, heat or power shall be installed in rigid galvanized or sherardized metal. threaded conduit, and galvanized metal outlet boxes, cut-out and distribution cabinets and fittings installed. Conduits shall be installed in such manner that they will drain to the outlets and cabinets conductors installed in con- duit must comply with the National Electrical Code Standard for damp or wet locations. All conduits entering or leaving refrigeration boxes must have an approved seal -off fitting. (q) The minimum wire capacity for window display lighting shall be not less than 100 watts per linear foot and shall not exceed. six outlets per circuit including the convenience receptacles and not more than two receptacles with each lighting circuit. The minimum size wire for these circuits shall be 20 amp. capacity. A minimum of two outlets shall be required at least one above the one below. All fixed lighting shall be equipped with switches. (r) Permanently installed electrical space heaters :in.bath- rooms shall be installed so that heaters will not be easily exposed to combustible materials. But said heaters shall not be installed behind doors, under or near towel racks, or near shower curtains or window curtains. Each heater must be on a separate circuit with a minimum wire size of No. 12 AWG or larger. (s) One branch -circuit for signs shall be provided for each store frontage for each individual occupancy, said outlets to termi - nate outside, on or near the front of the building. Sign outlets and window lighting. shall be controlled by wall switches. (It is suggested that these switches be installed near panel, so that time clock instal- lation, if desired, will be conveniently located and less unsightly. ) (t) Sufficient bathroomand toilet lighting must be installed 28 a Ok . �. PAGE134 FEB :2 11961