2013-018B - Laserfiche WebLink

Home Browse Search

D. Each and every provision of law and clause required by law to be inserted in these Contract ( Documents shall be deemed to be inserted herein, and they shall be read and enforced as though it were included herein SC3.03A.3 Delete existing 3.03A.3 of the General Conditions in its entirety and replace it with the following: Contractor shall not be liable to Owner or Engineer for failure to report any such conflict, error, ambiguity, or discrepancy in the Contract Documents unless Contractor knew or, in the exercise of ordinary care, reasonably should have recognized such conflict, error, ambiguity, or discrepancy and failed to report it in writing to the Owner and the Engineer. SC 3.03B Delete existing 3.03B of the General Conditions in its entirety and replace it with the following B. Resolving Discrepancies. Except as may be otherwise specifically stated in the Contract Documents, the provisions of the Contract Documents shall be read together as a whole not in isolation so as to give meaning to each provision; however, to the extent there is a conflict or inconsistency between or among provisions, the strictest or most stringent standard shall apply. ARTICLE 4 - AVAILABILITY OF LANDS; SUBSURFACE DPHYSICAL CONDITIONS; HAZARDOUS ENVIRONMENTAL CONDITIONS; REFERENCE POINT SC 4.01 A Delete existing paragraph 4.01 A of the General Conditions in its entirety and replace it with the following: A. Owner shall furnish the site. SC 4.01 B Delete existing paragraph 4.01 B of the General Conditions in its entirety. SC 4.02A Delete 4.02 A.1 of the General Conditions in its entirety and replace it with the following: A. Reports and Drawings: The Contract Documents may identify those reports of explorations and tests of subsurface conditions at or contiguous to the Site that Engineer has used in preparing the Contract Documents. Engineer has relied upon the data obtained from subsurface investigations made at the site in the form of test borings. Such data is in the form of boring logs, which are available upon request. The locations of the test borings are indicated on the Drawings. Such logs and samples are not part of the Contract Documents. SC -4.02A.2. Add the following new sentences immediately at the end of existing paragraph 4.02A.2. of the General Conditions which is to read as follows: In the preparation of Drawings and Specifications, the Engineer has relied upon the reports listed in Section 00200 and tests of subsurface physical conditions at the site. Copies of these reports are available upon request. The foregoing information and data shown or indicated in the Contract Documents is based on information and data furnished to Owner or the Engineer by others. The, Owner and Engineer shall not beresponsible or the accuracy or full responsibility for requesting,reviewing,ewof nngSand y such information or data, and the Contractor have checking all such information and data. 00800-4