Laserfiche WebLink
base Shop Drawings on reproductions of the Contract Documents or standard printed <br /> data. <br /> 1. Preparation: Include the following information, as applicable: <br /> a. Dimensions. <br /> b. Identification of products. <br /> c. Fabrication and installation drawings. <br /> d. Roughing-in and setting diagrams. <br /> e. Shopwork manufacturing instructions. <br /> f. Templates and patterns. <br /> g. Schedules. <br /> h. Notation of coordination requirements. <br /> i. Notation of dimensions established by field measurement. <br /> 2. Sheet Size: Except for templates, patterns, and similar full-size drawings, submit <br /> Shop Drawings on sheets at least 8-1/2 by 11 inches but no larger than 30 by 42 <br /> inches. <br /> D. Contractor's Construction Schedule: Comply with requirements in Division 01. <br /> E. Qualification Data: Prepare written information that demonstrates capabilities and <br /> experience of firm or person. Include lists of completed projects with project names and <br /> addresses,names and addresses of engineers and owners,and other information specified. <br /> F. Product Certificates: Prepare written statements on manufacturer's letterhead certifying <br /> that product complies with requirements. <br /> G. Installer Certificates: Prepare written statements on manufacturer's letterhead certifying <br /> that Installer complies with requirements and, where required, is authorized for this <br /> specific Project. <br /> H. Manufacturer Certificates: Prepare written statements on manufacturer's letterhead <br /> certifying that manufacturer complies with requirements. Include evidence of <br /> manufacturing experience where required. <br /> Material Certificates: Prepare written statements on manufacturer's letterhead certifying <br /> that material complies with requirements. <br /> J. Material Test Reports: Prepare reports written by a qualified testing agency, on testing <br /> agency's standard form, indicating and interpreting test results of material for compliance <br /> with requirements. <br /> K. Product Test Reports: Prepare written reports indicating current product produced by <br /> manufacturer complies with requirements. Base reports on evaluation of tests performed <br /> by manufacturer and witnessed by a qualified testing agency, or on comprehensive tests <br /> performed by a qualified testing agency. <br /> L. Design Data: Prepare written and graphic information, including, but not limited to, <br /> performance and design criteria,list of applicable codes and regulations,and calculations. <br /> Include list of assumptions and other performance and design criteria and a summary of <br /> loads. Include load diagrams if applicable. Provide name and version of software,if any, <br /> used for calculations. Include page numbers. <br /> Sebastian Corners Roof Replacement 01 33 00-3 Submittal Procedures <br />