Laserfiche WebLink
IRC-1838 Indian River County <br />Main Library <br />Roof Replacement 07 71 19-1 Manufactured Gravel Stops and Fascias <br />SECTION 07 71 19 <br />MANUFACTURED GRAVEL STOPS AND FASCIAS <br /> GENERAL <br />1.1 SECTION INCLUDES <br />A. Provide factory fabricated and finished roof edging. <br />1.2 RELATED SECTIONS <br />A. Drawings and general provisions of the Contract, including General and Supplementary <br />Conditions and Specification Sections, apply to this Section, including but not limited to: <br />1. Rough Carpentry Section 06 10 00 <br />2. Modified Bitumen Roofing Section 07 52 16 <br />3. Sheet Metal Flashings and Trim Section 07 62 00 <br />1.3 REFERENCES <br />A. 2017 Florida Building Code <br />B. FM Global <br />C. ANSI/SPRI ES-1 <br />1.4 SUBMITTALS <br />A. Refer to Section 01 33 00-Submittal Procedures. <br />B. Manufacturer’s Product Data Sheets for all materials specified certifying material complies <br />with all specified requirements. <br />C. Latest edition of the Manufacturer’s current material specifications and installation <br />instructions. <br />D. Shop drawings: Show profiles, joining method, location of accessory items, anchorage and <br />flashing details, adjacent construction interface, and dimensions. <br />E. Samples: Available on request; sized to adequately represent material. <br />1.5 QUALITY ASSURANCE <br />A. High performance roof edge shall be CERTIFIED by the manufacturer to comply with <br />ANSI/SPRI Standard ES-1. Roof edge/gravelstop shall meet performance design criteria <br />according to the following test standards: [select, if applicable]: <br />1. ANSI/SPRI ES-1 Test Method RE-1 Test for Roof Edge Termination of Single-ply <br />Roofing Membranes: The fascia system shall be tested to secure the membrane <br />to minimum 100 lbs/ft in accord with the ANSI/SPRI ES-1 Test Method RE-1. Use <br />the current edition of ANSI/SPRI ES-1 Wind Design Standard for Edge Systems <br />Used with Low Slope Roofing Systems. <br />2. ANSI/SPRI ES-1 Test Method RE-2 Pull-Off Test for Fascia: The fascia system <br />shall be tested in accord with the ANSI/SPRI ES-1 Test Method RE-2. Use the <br />current edition of ANSI/SPRI ES-1 Wind Design Standard for Edge Systems Used <br />with Low Slope Roofing Systems. <br />3. The roof edge product shall be UL Classified by Underwriters Laboratories, Inc. or