Laserfiche WebLink
IRC-1838 Indian River County <br />Main Library <br />Roof Replacement 07 71 19-2 Manufactured Gravel Stops and Fascias <br />other 3rd party verification of compliance with the ANSI/SPRI ES-1 Wind Design <br />Standard. <br />1.6 DELIVERY, STORAGE AND HANDLING <br />A. All materials shall be delivered in the manufacturer’s original sealed, labeled containers. <br />B. Store materials in a dry, protected, well-vented area. The contractor shall report damaged <br />material immediately to the delivering carrier and note such damage on the carrier’s freight <br />bill of lading. <br />C. Remove protective plastic surface film after installation. <br />1.7 PROJECT CONDITIONS <br />A. Verify that other trades are complete before installing the roof edging. <br />B. Mounting surfaces shall be straight and secure; substrates shall be of proper width. <br />C. Refer to the construction documents, shop drawings and manufacturer’s installation <br />instructions. <br />D. Coordinate installation with roof membrane manufacturer’s installation instructions. <br />E. Observe all appropriate OSHA safety guidelines for this work. <br />1.8 WARRANTY/GUARANTEE <br />A. Shall be included in Roof System Warranty as specified in Section 07 54 00: <br />1. Manufacturer shall guarantee that a standard size roof edge system, when <br />installed per manufacturer’s instructions, will not blow off, leak, or cause <br />membrane failure, even in wind conditions up to 215 mph (extruded aluminum <br />cleat), or the manufacturer shall replace or repair its materials for a period of twenty <br />years. <br />2. Finish Warranty: Shall be thirty (30) years. <br /> PRODUCTS <br />2.1 MANUFACTURER: <br />A. The following manufacturer's are approved for use: <br />1. W. P. Hickman Company <br />2. Metal Era <br />3. OMG Roofing Products <br />4. Engineer's accepted equivalent <br />2.2 ROOF EDGE: <br />A. Pre-manufactured Edge Metal: Decorative metal fascia with continuous extruded <br />aluminum bar. <br />1. Construction: <br />a. Fascia metal gauge: <br />i. .040 inch (1 mm) thick formed aluminum.