Laserfiche WebLink
ORDINANCE NO. 2000- 015 <br />2. Preliminary Plat Initial (pre -TRC) Submittal: <br />LDR SUBDIVISION Chapter Section 913.07(4)(A)l.c. is hereby amended as follows. <br />(4) Preliminary plat application and review. <br />(A) Submission of application. <br />1. Upon completion of the formal pre -application conference, the applicant may <br />apply for preliminary plat approval. At his or her option, an applicant may <br />simultaneously apply for preliminary plat approval and for land development <br />permit review. No land development permit may be issued until the <br />preliminary plat is approved. An applicant shall apply for preliminary plat <br />approval by furnishing to the community development director: <br />a. A complete application form, as provided by the community <br />development department; <br />b. The appropriate filing fee established by the board of county <br />commissioners; <br />C. Seven (5) eepies Ten (10) sets of the plat drawings and a written <br />response to each item in the project's pre -application conference <br />discrepancy letter or a written description of all revisions made to the <br />project plans since the pre -application conference review; <br />3. Preliminary Plat Resubmittal (post -TRC): <br />LDR SUBDIVISION Chapter Section 913.07(4)(F)I.e. is hereby amended as follows: <br />e. The applicant shall respond, in writing, to each comment following receipt of the <br />discrepancy letter and submit sevenpies five (5) sets of a revised preliminary <br />plat if deemed necessary by the community development staff with a written response <br />to each item in the project's TRC discrepancy letter and a written request to be placed <br />on the planning and zoning commission's agenda for approval. <br />4. Final Plat Initial (pre -TRC) Submittal: <br />LDR SUBDIVISION Chapter Section 913.07(6)(B)6 is hereby amended to read as follows: <br />6. Seven (9) Ten 10 copies of the final plat drawing showing required information and <br />certifications. <br />Staff Note: There is no need to change the final plat drawing set requirement for final plat <br />resubmittals (post -TRC) because the final plat review procedures merely reference the preliminary <br />plat section 913.07(4)(F) that is being amended under #3, above. Thus, the #3 amendment will <br />reduce final plat drawing sets from 7 to 5. <br />MAY 09, 2000 <br />-47- BOOK c PAGE -Stj <br />