Laserfiche WebLink
1.08 SPARE PARTS <br />A. The following spare parts shall be furnished for each pump provided: <br />1. One mechanical seal assembly <br />2. Two complete sets of gaskets, "O" rings, etc. <br />B. Store spare pumps, parts, drivers, etc. in strict accordance with manufacturer's <br />recommendations. Notify the owner in writing of any special storage maintenance required, <br />and provide such maintenance until final acceptance of contract. <br />PART 2 - PRODUCTS <br />2.01 GENERAL <br />A. The equipment covered by these Specifications is intended to be standard pumping <br />equipment of proven ability as manufactured by reputable manufacturers having at least five <br />(5) years of experience in the production of such equipment. The equipment furnished shall <br />be designed, constructed, and installed in accordance with the best practice and methods, and <br />shall operate satisfactorily when installed as shown on the Drawings. <br />B. All parts shall be so designed and proportioned as to have liberal strength and stiffness and to <br />be especially adapted for the work to be done. Ample room and facilities shall be provided <br />for inspection, repairs and adjustment. <br />C. The Manufacturer shall be fully responsible for the design, arrangement, and operation of all <br />connected rotating components of the assembled pumping unit to ensure that neither harmful <br />nor damaging vibrations occur at any speed within the specified operating range. Design <br />shall include all supporting sole plates and fabricated steel base plate for mounting the units. <br />D. Pump shall be rigidly and accurately anchored into position, precisely leveled and aligned, so <br />that the completed installation is free from stress or distortion. All necessary foundation <br />bolts, plates, nuts and washers shall be furnished and installed by the Contractor and conform <br />to the recommendations and instructions of the equipment Manufacturer. Anchor bolts, nuts, <br />and washers shall be of Type 316 stainless steel. Grouting under bases after the equipment is <br />set is included as work under this Section. <br />E. Stainless steel nameplates giving the name of the Manufacturer, the rated capacity, head, <br />speed, and any other pertinent data shall be attached to each pump. <br />F. Stainless steel nameplates giving the name of the Manufacturer, serial number, model <br />number, horsepower, speed, voltage, amperes and all other pertinent data shall be attached to <br />each motor. <br />G. All pumps shall be designed and built for 24-hour continuous service at any and all points <br />within the specified range of operation, without overheating, without cavitation, and without <br />excessive vibration or strain. <br />044572017 <br />11934-4 <br />